I'm new with UNIX, i have a pseries server from IBM and i need to install AIX 4.3, i never used wyse terminal or AIX, i need help to know how to install it, i have the server and the wyse i get in into the aixterm, over com1 but i don't know wich command use or what to do to install it..... ... (0 Replies)
Hi All --
I have an old 7028-6C1 which I'm using to learn AIX. The system didn't include a graphics card, so I connected via the serial port and performed a fresh install of AIX 5L V5.3.
Later, I purchased a GXT135P (2849) graphics card, and added it to the system. When I ran diag, I was able... (2 Replies)
Hello Gurus,
i'm quite new person in AIX world, actually i'm SAP consultant. But due to my job faced with AIX.
Trying to configure new server for installation SAP. We have 4 disks one of them (hdisk3) has VG rootvg. How i can extend rootvg with another disk?
i tried:
# extendvg rootvg hdisk0... (2 Replies)
Anyone can help me answer the question.
Why does they use Linux on IBM pSeries not AIX.
I can't understand why, cause AIX is the best supporting from IBM pSeries.
Tks you. (3 Replies)
Hi ,
I am planing to buy IBM pSeries Power5 9111-285 1,9 GHz but I am confused with few things. I would be happy if you could clear it up for me ?
1.Do I have to buy some license in order to create Lpars ?
2.Do I have to buy some license in order to use HMC , micro - partiocioning , VIOS... (4 Replies)
Hello,
I installed PowerVM IVM Virtual I/O on P-550 but later found out that the machine isn't activated for CoD VET code for virtualization.
So when booted , it goes into OPEN Firmware
I/O Hosting requires a hosting partition boot not permitted exit called
> ok
Panel shows > IO... (3 Replies)
Hidey Ho Folks,
Looking to buy a pServer for playing around with the IBM side of things. Looked around for a bit and notice that there is a significant price gap for the used 570's (Single Units) vs the 520's and 550's that folks are selling. Curious what to watch out for in either case? And... (6 Replies)
Hello,
I'm very rookie to AIX and attempting to install AIX. I have vio ready on the machine and don't know how to install OS? Inserted Volume 1 DVD into the ROM, don't know what to do next. Searched many forum but cant find the this basic thing. Please let me know how to install AIX on this... (4 Replies)
Hi There,
I have zero information and zero knowledge for IBM virtual machine except Amazon cloud and VMware ESXi (Only Linux OS available).
Anyone could provide me the following answer -
Can IBM VM been deploy on X86 and X64 (Intel Chip)?
If answer is yes any chance to deploy AIX OS... (13 Replies)
Discussion started by: chenyung
13 Replies
LEARN ABOUT NETBSD
pcn
PCN(4) BSD Kernel Interfaces Manual PCN(4)NAME
pcn -- AMD PCnet-PCI Ethernet family driver
SYNOPSIS
pcn* at pci? dev ? function ?
Configuration of PHYs may also be necessary. See mii(4).
DESCRIPTION
The pcn device driver supports Ethernet interfaces based on the AMD PCnet-PCI family of Ethernet chips. The chips supported by the pcn
driver include:
o Am79c970 PCnet-PCI Single-Chip Ethernet Controller for PCI Local Bus
o Am79c970A PCnet-PCI II Single-Chip Full-Duplex Ethernet Controller for PCI Local Bus
o Am79c971 PCnet-FAST Single-Chip Full-Duplex 10/100Mbps Ethernet Controller for PCI Local Bus
o Am79c972 PCnet-FAST+ Enhanced 10/100Mbps PCI Ethernet Controller with OnNow Support
o Am79c973/Am79c975 PCnet-FAST III Single-Chip 10/100Mbps PCI Ethernet Controller with Integrated PHY
PCnet-PCI chips are found on some Hewlett-Packard PCI Ethernet boards, and on the Allied Telesyn AT-2700TX PCI Ethernet board. They are also
found on some processor evaluation boards as an example peripheral.
The pcn driver also supports the emulated PCnet-PCI interface provided by VMware.
SEE ALSO arp(4), ifmedia(4), mii(4), netintro(4), pci(4), ifconfig(8)HISTORY
The pcn driver first appeared in NetBSD 1.6.
AUTHORS
The pcn driver was written by Jason R. Thorpe <thorpej@wasabisystems.com>.
BSD August 27, 2001 BSD