Sponsored Content
Special Forums Hardware Need Sun 10-Gigabit Ethernet Adapter CD or ixge driver Post 302750729 by Lhao on Wednesday 2nd of January 2013 11:01:05 AM
Old 01-02-2013
Thank you

Thank you DukeNuke2. I'm going to see whether I can find the patch you pointed out. You are very helpful.
 

10 More Discussions You Might Find Interesting

1. AIX

Network performance problem between AIX and SUN ethernet gigabit

I am posting this as an FYI. I burned a lot of time on digging for this solution. The problem was performance between newer AIX p series boxes and a sun 4500 with a fiber nic. I tried many misc. solutions but this turned out to fix the issue. My bandwidth benchmark went from around 20MB/sec to... (1 Reply)
Discussion started by: chuckw
1 Replies

2. UNIX for Dummies Questions & Answers

How to change the MAC adress in ethernet adapter for SUN

I have installed in the server a quad ethernet adapter, I'm using two interfaces with two different IP networks, both interfaces are connected to a switch, the switch report that is receiving the same MAC address in both ports so must of the times I have connectivity problems. Any idea to change... (1 Reply)
Discussion started by: mono673
1 Replies

3. SCO

Configuring Broadcom BCM5721 NetXtreme Gigabit Ethernet

Hi, I have my server which has LAN with above model build onboard my Dell Server, I got this driver from SCO Unix website but yet to identify the following option: 1. PCI Slot- 2. Bus- 3. Device- 4. Function- Would anyone please kindly advice what should the... (0 Replies)
Discussion started by: spiderweb
0 Replies

4. Solaris

Ethernet Adapter Question

I have a Dual Boot system - XP with Solaris 10. I built the system from the ground up with different components and the Ethernet Card built into the Motherboard is a Marvell Yukon Gigabit Ethernet 10/100/1000 T-base, RJ-45 Copper. I am unable to go to the Web as the Ethernet Card is still not... (2 Replies)
Discussion started by: tubbyrana
2 Replies

5. Solaris

How to install ethernet adapter on Sun Sparc M4000

hi all, How to install onboard ethernet card on Sun SPARC M4000 server? (3 Replies)
Discussion started by: Tlg13team
3 Replies

6. Solaris

SUN GIGABIT ETHERNET CARD

Hi, we have SUN Gigabit ethernet cards at the server, both have 2 lines connected but hiw can I found out which cable is on which port before I configure it: the cards has 4 ports , from right to left the cables are connected at the first right then 2 empty then the last at the left side. ... (1 Reply)
Discussion started by: manni2
1 Replies

7. AIX

Setting up an Integrated Virtual Ethernet adapter

All I am trying allocate an IVE to an LPAR (not a VIO) running AIX 7.1. I am getting the error: HSCL068A Explanation Logical port can not be assigned to Logical Partition because this Logical Partition is not the promiscuous LPAR for the physical port. Has anyone encountered this... (1 Reply)
Discussion started by: johnf
1 Replies

8. Red Hat

Ethernet Adapter not detected.

Hi, I have installed Oracle Enterprise Linux 5 in my PC. After the installation the Ethernet Card is not got detected. But I could able to get the details using the command lspci -a: 01:00.0 Ethernet controller: Attansic Technology Corp. L1 Gigabit Ethernet Adapter (rev b0). But I could... (4 Replies)
Discussion started by: chidhu.anu
4 Replies

9. Solaris

Qlogic 10G Ethernet adapter not working

Hi Community, i have one issue with 10 fiber ethernet adapter. here is my details: root@new-bpel.example.com #dladm show-dev bge0 link: unknown speed: 0 Mbps duplex: unknown bge1 link: up speed: 1000 Mbps duplex: full qlge2 link:... (4 Replies)
Discussion started by: bentech4u
4 Replies

10. Red Hat

Red Hat 7 cannot recognize ethernet adapter

Hello community, I have a Proliant HP DL380P with the following network adapters: NetXtreme BCM5719 Gigabit Ethernet PCIe (Ethernet 1Gb 4-port 331FLR Adapter) 82580 Gigabit Network Connection (NC365T 4-port Ethernet Server Adapter) I installed Red Hat 7.2 but it recognizes only the... (9 Replies)
Discussion started by: Lord Spectre
9 Replies
WM(4)							   BSD Kernel Interfaces Manual 						     WM(4)

NAME
wm -- Intel i8254x Gigabit Ethernet driver SYNOPSIS
wm* at pci? dev ? function ? Configuration of PHYs may also be necessary. See mii(4). DESCRIPTION
The wm device driver supports Gigabit Ethernet interfaces based on the Intel i8254x family of Gigabit Ethernet chips. The interfaces sup- ported by the wm driver include: o Intel i82542 1000BASE-X Ethernet o Intel i82543GC 1000BASE-X Ethernet o Intel i82543GC 1000BASE-T Ethernet o Intel i82544EI 1000BASE-T Ethernet o Intel i82544EI 1000BASE-X Ethernet o Intel i82544GC 1000BASE-T Ethernet o Intel i82544GC (LOM) 1000BASE-T Ethernet o Intel i82540EM 1000BASE-T Ethernet o Intel i82540EM (LOM) 1000BASE-T Ethernet o Intel i82540EP 1000BASE-T Ethernet o Intel i82541EI 1000BASE-T Ethernet o Intel i82541EI (Mobile) 1000BASE-T Ethernet o Intel i82541ER 1000BASE-T Ethernet o Intel i82541GI 1000BASE-T Ethernet o Intel i82541PI 1000BASE-T Ethernet o Intel i82545EM 1000BASE-T Ethernet o Intel i82545EM 1000BASE-X Ethernet o Intel i82545GB 1000BASE-T Ethernet o Intel i82545GB 1000BASE-X Ethernet o Intel i82545GM 1000BASE-T Ethernet o Intel i82546EB 1000BASE-T Ethernet (dual-port) o Intel i82546EB 1000BASE-X Ethernet (dual-port) o Intel i82546GB 1000BASE-T Ethernet (dual-port) o Intel i82546GB 1000BASE-X Ethernet (dual-port) o Intel i82547EI 1000BASE-T Ethernet (CSA) o Intel i82547GI 1000BASE-T Ethernet (CSA) o Intel i82571 1000BASE-T Ethernet (dual-port) o Intel i82572 1000BASE-T Ethernet o Intel i82573 1000BASE-T Ethernet o Intel i82575 1000BASE-T Ethernet o Intel i82576 Ethernet (Copper, Fiber) o Intel i80003 Ethernet (Copper, Fiber) o Intel i82801H (ICH8 LAN) 1000BASE-T Ethernet o Intel i82801I (ICH9 LAN) 1000BASE-T Ethernet o Intel i82801J (ICH10 LAN) 1000BASE-T Ethernet o Intel 82578 with Intel 5 series chipset (PCH) o Intel 82579 with Intel 6 or 7 series chipset (PCH2) o Intel 82580 Ethernet (Copper, Fiber) o Intel 82583 1000BASE-T Ethernet o Intel I350 Ethernet (Copper, Fiber) In addition to Intel's own ``PRO/1000'' line of Gigabit Ethernet interfaces, these chips also appear on some server systems, processor evalu- ation boards, and in embedded systems. The i8254x supports IPv4/TCP/UDP checksumming and TCP segmentation in hardware. The wm driver supports these features of the chip. See ifconfig(8) for information on how to enable this feature. SEE ALSO
arp(4), ifmedia(4), mii(4), netintro(4), pci(4), ifconfig(8) HISTORY
The wm driver first appeared in NetBSD 1.6. AUTHORS
The wm driver was written by Jason R. Thorpe <thorpej@wasabisystems.com>. BUGS
The Intel i82545GM and i82546GB controllers with internal SERDES are not currently supported. BSD
June 20, 2012 BSD
All times are GMT -4. The time now is 04:26 AM.
Unix & Linux Forums Content Copyright 1993-2022. All Rights Reserved.
Privacy Policy