MacBook Air: Cannot select Ethernet during Setup Assistant Post: 302476323

Sponsored Content

Operating Systems OS X (Apple) OS X Support RSS MacBook Air: Cannot select Ethernet during Setup Assistant Post 302476323 by Linux Bot on Wednesday 1st of December 2010 12:15:01 PM

12-01-2010

Registered User

MacBook Air: Cannot select Ethernet during Setup Assistant

After you start up your MacBook Air for the first time and connect a USB Ethernet adapter during the Setup Assistant, the Setup Assistant may not allow you to select Ethernet to transfer your information from another Mac or to configure your Internet connection.

More from Apple OS X Support ...

Linux Bot

View Public Profile for Linux Bot

Find all posts by Linux Bot

2 More Discussions You Might Find Interesting

1. What is on Your Mind?

MacBook Air Anyone?

I am thinking to purchase a new MacBook Air, 13 inch. Anyone have a MacBook Air? What do you think about it? Seems expensive, a bit. Is it worth it?

2. OS X (Apple)

Upgrade to Lion (Version 10.7.3) for MacBook Air

Anyone running Lion on their Mac? I'm currently running Snow Leopard (v. 10.6.8) and have been hesitant to upgrade to 10.7.X. Anyone at all running Lion? Any experiences good or bad to report? Thanks!

LEARN ABOUT NETBSD

urlphy

URL(4)							   BSD Kernel Interfaces Manual 						    URL(4)

NAME

     url -- Realtek RTL8150L USB Ethernet driver

SYNOPSIS

     url*    at uhub?
     urlphy* at mii?

DESCRIPTION

     The url driver provides support for USB Ethernet adapters based on the Realtek RTL8150L USB-ether bridge chip.

     The url driver supports the following adapters:

	   CompUSA USBKR100
	   GreenHouse GH-USB100B
	   Melco Inc. LUA-KTX
	   Sitecom LN013

     For more information on configuring this device, see ifconfig(8).

DIAGNOSTICS

     url%d: watchdog timeout  A packet was queued for transmission and a transmit command was issued, however the device failed to acknowledge the
     transmission before a timeout expired.

     url%d: no memory for rx list  The driver failed to allocate an mbuf for the receiver ring.

SEE ALSO

     arp(4), mii(4), netintro(4), usb(4), ifconfig(8)

HISTORY

     The url device driver first appeared in NetBSD 1.6.

AUTHORS

     The url driver was written by Shingo WATANABE <nabe@nabechan.org>.

BSD
								September 18, 2006							       BSD