QLXGE(4)						   BSD Kernel Interfaces Manual 						  QLXGE(4)

NAME

     qlxge -- QLogic 8100 Series 10 Gigabit Ethernet Adapter Driver

SYNOPSIS

     To compile this driver into the kernel, place the following lines in your kernel configuration file:

	   device qlxge

     To load the driver as a module at boot time, place the following line in loader.conf(5):

	   if_qlxge_load="YES"

DESCRIPTION

     The qlxge driver supports IPv4 checksum offload, TCP and UDP checksum offload for both IPv4 and IPv6, Large Segment Offload for both IPv4 and
     IPv6, Jumbo frames, VLAN Tag, and Receive Side scaling.  For further hardware information, see http://www.qlogic.com/.

HARDWARE

     The qlxge driver supports 10 Gigabit Ethernet & CNA Adapter based on the following chipsets:

     o	 QLogic 8100 series

SUPPORT

     For support questions please contact your QLogic approved reseller or QLogic Technical Support at http://support.qlogic.com, or by E-mail at
     <support@qlogic.com>.

SEE ALSO

     altq(4), arp(4), netintro(4), ng_ether(4), ifconfig(8)

HISTORY

     The qlxge device driver first appeared in FreeBSD 10.0.

AUTHORS

     The qlxge driver was written by David C Somayajulu at QLogic Corporation.

BSD
								   June 21, 2013							       BSD