07-29-2008
7 More Discussions You Might Find Interesting
1. UNIX for Dummies Questions & Answers
I have two sparcstation20's. One has no hard drive or memory and I want to know if there is a way to take the processor out of it and make the other a dual processor. I know it is possible some how just curious if anyone here can help me make this happen. (Don't know much about sun... (3 Replies)
Discussion started by: jwbrown
3 Replies
2. UNIX for Dummies Questions & Answers
I have a console server that runs some form of UNIX/Linux, but I get a bash shell, and I want to determine how many processor (what speed) and them amount of RAM in the system. (2 Replies)
Discussion started by: bbrandeb49
2 Replies
3. HP-UX
Everyone seemed to be a little stumped by the multicore question I asked earlier this week, so I decided I'd try a different angle.
Turns out that on a multicore system HP-UX reports every core as a seperate processor. All the usual commands (ioscan, top, etc.) report two processors for every... (7 Replies)
Discussion started by: Midcain
7 Replies
4. HP-UX
I'm fairly new to HP-UX, and I need to know how to identify the number of cores on a PA-8800 processor from the command line. Any help here would be appreciated. (11 Replies)
Discussion started by: Midcain
11 Replies
5. UNIX for Advanced & Expert Users
which unix command can be used to know the no: of processors running on that machine...
version used:- Solaris 8.0 (3 Replies)
Discussion started by: bishweshwar
3 Replies
6. AIX
Question is on setting of Physical and Virtual processors for LPARs to make proper use of virtualization capabilities.
Environment is a 8-way p570 with 4 LPARs.
lparVIO1 and lparVIO2:
AIX 5300-04-01
Mode/Type= Shared-SMT/Capped
Minimum Processors= 0.10
Desired Processors= 0.50
Maximum... (1 Reply)
Discussion started by: guttew
1 Replies
7. AIX
Guys...
Hows it going???
I have been going through the hardware spec of IBM system p systems.. and here i am confused
for IBM Power 520 Express it says
Processor cores:
One, two or four 64-bit 4.2 GHz POWER6 with AltiVec™ SIMD and Hardware Decimal Floating-Point acceleration
... (1 Reply)
Discussion started by: balaji_prk
1 Replies
URL(4) BSD Kernel Interfaces Manual URL(4)
NAME
url -- Realtek RTL8150L USB Ethernet driver
SYNOPSIS
url* at uhub?
urlphy* at mii?
DESCRIPTION
The url driver provides support for USB Ethernet adapters based on the Realtek RTL8150L USB-ether bridge chip.
The url driver supports the following adapters:
CompUSA USBKR100
GreenHouse GH-USB100B
Melco Inc. LUA-KTX
Sitecom LN013
For more information on configuring this device, see ifconfig(8).
DIAGNOSTICS
url%d: watchdog timeout A packet was queued for transmission and a transmit command was issued, however the device failed to acknowledge the
transmission before a timeout expired.
url%d: no memory for rx list The driver failed to allocate an mbuf for the receiver ring.
SEE ALSO
arp(4), mii(4), netintro(4), usb(4), ifconfig(8)
HISTORY
The url device driver first appeared in NetBSD 1.6.
AUTHORS
The url driver was written by Shingo WATANABE <nabe@nabechan.org>.
BSD
September 18, 2006 BSD