|
|
Sponsored Content
Top Forums
UNIX for Dummies Questions & Answers
PCMCIA Hardware Problem
Post 11439 by ghoti on Wednesday 5th of December 2001 11:46:58 AM
12-05-2001
|
|
10 More Discussions You Might Find Interesting
1. Solaris
Can someone tell me what the following means? We have a v440 running Solaris 9. What do the patterns actually mean?
May 17 12:12:03 ibasdb02 cediag: Revision: 1.78 @ 2005/02/11 15:5
:29 UTC
May 17 12:12:03 ibasdb02 cediag: Analysed System: SunOS 5.9 with
UP 117171-17 (MPR active)
May 17... (5 Replies)
Discussion started by: hshapiro
5 Replies
2. UNIX for Advanced & Expert Users
I have worked with Qlogic (Sun) fiber cards a lot and with Emulex fiber cards only a little. Here is the scenario: I have a Sun 490 with 3 Emulex cards in it. A pair are for the 6120 array that is attached, the other is a direct attach so our SAN for Veritas Netbackup to back up the system.I... (0 Replies)
Discussion started by: lm_admin_dh
0 Replies
3. Solaris
Dear All
I would Like to know that if suppose c1t0d0 is of 72 gb hard disk and system boot from this hard disk and c1t1d0 is of 147gb hard disk. Can we implement hardware raid (Mirror) between these two hard disks of different capacity if raid crontroller is present in the server
Kind regards (4 Replies)
Discussion started by: girish.batra
4 Replies
4. Solaris
Hi
I am right now facing a strange hardware problem. System get booted with the following error:
Fatal Error Reset
CPU 0000.0000.0000.0003 AFSR 0100.0000.0000.0000 SCE
AFAR 0000.07c6.0000.1000
SC Alert: Host System has Reset
It happen 4 or 5 times and get the same error every time.I... (8 Replies)
Discussion started by: girish.batra
8 Replies
5. Linux
Hey guys how to do diagnose Linux for hardware problems/issues. This is a general question for all common hardware components under Linux server. (1 Reply)
Discussion started by: sbn
1 Replies
6. Solaris
Hey guys how to do diagnose solaris for hardware problems/issues. This is a general question for all common hardware components under solaris server. (4 Replies)
Discussion started by: sbn
4 Replies
7. HP-UX
Hey guys how to do diagnose HP-UX for hardware problems/issues. This is a general question for all common hardware components under HP-UX server. (4 Replies)
Discussion started by: sbn
4 Replies
8. BSD
Hi there. I have an old laptop Toshiba Tecra 510 (P1, 147MB RAM, 30GB HDD) and I installed FreeBSD 7.2.
For networking I have a PCMCIA card for wired network. The problem is that I cannot start and run PCMCIA
As I know in Linux there is a tool pcmciautils for this pc-cards, but in FreeBSD I have... (1 Reply)
Discussion started by: hirohitosan
1 Replies
9. Solaris
First of all it's shut down 60 second after power on and write on console :
SC Alert: Correct SCC not replaced - shutting managed system down!
This is cured by moving out battery from ALOM card.
Now server start to loop during the testing.
That's on the console:
>@(#) Sun Fire V440,Netra... (14 Replies)
Discussion started by: Alisher
14 Replies
10. Solaris
Dear:
the Cureent PC Dell GX620
the Current Hardware
4 GB ram
80 HDD
what i do
remove old 4GB ram and install 8 GB
remove old HDD and install new on 160GB
try to install the Unix Sun Solaris
after booting and when arrive to step which i should select interactive
error meg... (7 Replies)
Discussion started by: hosney00ux
7 Replies
LEARN ABOUT NETBSD
urlphy
URL(4) BSD Kernel Interfaces Manual URL(4) NAME
url -- Realtek RTL8150L USB Ethernet driver SYNOPSIS
url* at uhub? urlphy* at mii? DESCRIPTION
The url driver provides support for USB Ethernet adapters based on the Realtek RTL8150L USB-ether bridge chip. The url driver supports the following adapters: CompUSA USBKR100 GreenHouse GH-USB100B Melco Inc. LUA-KTX Sitecom LN013 For more information on configuring this device, see ifconfig(8). DIAGNOSTICS
url%d: watchdog timeout A packet was queued for transmission and a transmit command was issued, however the device failed to acknowledge the transmission before a timeout expired. url%d: no memory for rx list The driver failed to allocate an mbuf for the receiver ring. SEE ALSO
arp(4), mii(4), netintro(4), usb(4), ifconfig(8) HISTORY
The url device driver first appeared in NetBSD 1.6. AUTHORS
The url driver was written by Shingo WATANABE <nabe@nabechan.org>. BSD
September 18, 2006 BSD