netbsd man page for xge

XGE(4)							   BSD Kernel Interfaces Manual 						    XGE(4)

NAME
     xge -- Neterion Xframe-I Ten Gigabit Ethernet driver

SYNOPSIS
     xge* at pci? dev ? function ?

DESCRIPTION
     The xge device driver supports the Neterion Xframe-I LR Ethernet adapter, which uses a single mode fiber (1310nm) interface.

     The Xframe supports IPv4/TCP/UDP checksumming in hardware, as well as TCP Segmentation Offloading (TSO) and hardware VLAN handling.  The
     driver currently does not support the hardware VLAN feature.  See ifconfig(8) for information on how to enable TSO and hardware checksum cal-
     culation.

DIAGNOSTICS
     xge%s: failed configuring endian, %llx != %llx!  The Xframe could not be turned into the correct endian operation.  This is most likely a
     hardware error.

     xge%d: failed allocating txmem.
     xge%d: failed allocating rxmem.  The computer has run out of kernel memory.

     xge%d: adapter not quiescent, aborting
     xge%d: ADAPTER_STATUS missing bits %s  The Xframe could not be turned into a usable state.  Most likely an Xframe hardware error.

     xge%d: cannot create TX DMA maps
     xge%d: cannot create RX DMA maps  This error is either a kernel error or that the kernel has run out of available memory.

     xge%d: bad compiler struct alignment, %d != %d  The compiler did not align the structure correctly.  This is a compiler problem.

SEE ALSO
     arp(4), ifmedia(4), netintro(4), pci(4), ifconfig(8)

HISTORY
     The xge driver first appeared in NetBSD 3.0.

AUTHORS
     The xge driver was written by Anders Magnusson <ragge@ludd.luth.se>.

BUGS
     There should be an XGMII framework for the driver to use.

BSD
								 September 9, 2005							       BSD