Unix/Linux Go Back    

NetBSD 6.1.5 - man page for stge (netbsd section 4)

Linux & Unix Commands - Search Man Pages
Man Page or Keyword Search:   man
Select Man Page Set:       apropos Keyword Search (sections above)

STGE(4) 			   BSD Kernel Interfaces Manual 			  STGE(4)

     stge -- Sundance/Tamarack TC9021 Gigabit Ethernet driver

     stge* at pci? dev ? function ?

     Configuration of PHYs or Ten-bit interfaces may also be necessary.  See mii(4).

     The stge device driver supports the Sundance/Tamarack TC9021 Gigabit Ethernet chip.

     The Sundance/Tamarack TC9021 is found on the D-Link DGE-550T, and the Antares Microsystems
     Gigabit Ethernet board.  It uses an external PHY or an external 10-bit interface.

     The TC9021 supports IPv4/TCP/UDP checksumming in hardware.  The stge driver supports this
     feature of the chip.  See ifconfig(8) for information on how to enable this feature.

     arp(4), ifmedia(4), mii(4), netintro(4), pci(4), ifconfig(8)

     The stge driver first appeared in NetBSD 1.6.

     The stge driver was written by Jason R. Thorpe <thorpej@NetBSD.org>.

     The stge driver does not support the VLAN tag insertion/removal feature of the TC9021 chip.
     This is primarily because the TC9021's VLAN do not have a useful programming interface.

     The stge driver does not yet support jumbo Ethernet frames.

     The stge driver does not yet function properly with 1000BASE-T fitted boards.  Currently,
     only 1000BASE-SX boards work.

BSD					  July 24, 2001 				      BSD
Unix & Linux Commands & Man Pages : ©2000 - 2018 Unix and Linux Forums

All times are GMT -4. The time now is 04:31 AM.