Sponsored Content
Special Forums IP Networking Quick Poll: Solaris IP Multipathing Post 44390 by RTM on Friday 5th of December 2003 08:57:18 AM
Old 12-05-2003
I have never seen it set up on any servers - but then again, most of the servers were running Solaris 2.6 or did not have the hardware.

It is being implemented in other parts of the company I work for - (different areas have different ideas of what should be done). Or at least it is known and suggested.

I think it's not out there much because you don't normally get failures on interface cards. If the failure rate was higher, then it would be used more. I've seen more cables go bad than cards (due to clumsy people) and it's normally fixed at the same time it was broken. I can't remember the last time a system was down due to an interface card.
 

7 More Discussions You Might Find Interesting

1. Solaris

Quick question about Solaris =)

:D Just curious, I know that solaris 2.0-2.x_present are System V UNIX... But, I have only used Solaris 10, 9 and 2.5... On a 2.5 Sparc box, after you login you get presented with the usual SunOS 5.5.1 then UNIX(R) System V Release 4.0 I know Solaris 9 and 10 do not include this banner... ... (0 Replies)
Discussion started by: ssorel
0 Replies

2. Solaris

solaris multipathing

I have solaris 10 sparc. I installed a Qlogic hba card. This card is connected on a brocade switch and the brocade is connected on 2 different controllers on a Hitachi disk bay. I formated 2 luns. On my solaris system, i have 4 disk. How to configure solaris 10 to fix the dual disk view. ... (4 Replies)
Discussion started by: simquest
4 Replies

3. Solaris

Solaris IP Multipathing (IPMP) Help

Hello All, I work for a Health care company at a local trauma hospital. I maintain a Picture Archiving and Communication System (PAC's). Basically, any medical images (X-Ray, CT, MRI, Mammo, etc) are stored digitally on the servers for viewing and dictation from diagnostic stations. I took over... (10 Replies)
Discussion started by: mainegeek
10 Replies

4. Solaris

Solaris IP Multipathing

Hi, I saw your post on the forums about how to setup IP multipathing. I wanted your help on the below situation . I have 2 servers A and B . Now they should be connected to 2 network switches . S1 and S2. Now is it possible to have IP Multipathing on each of the servers as follows ? ... (0 Replies)
Discussion started by: maadhuu
0 Replies

5. Solaris

Disable Inbuilt multipathing software of Solaris 10

Dear UNIX Gurus I need to know how to disable MPXIO feature (Inbuilt multipathing software of Solaris 10) as we are going to implemented iSCSI EMC based SAN. I am bit new to this feature so kindly suggest how to disable it Regards (4 Replies)
Discussion started by: girish.batra
4 Replies

6. Solaris

Solaris multipathing

Hai we using emc storage which is conneted to M5000 through san switch. we asign 13 luns but in server it is showing 22 luns. i enable the solaris multipathing (MPxIO) #more /kernel/drv/fp.conf in that file MPxio-disable=no #mpathadm list lu it shows ... (2 Replies)
Discussion started by: joshmani
2 Replies

7. Solaris

ZeusIOPS multipathing failed Solaris 11

hi, just installed solaris 11.1 (11.1.9.5.1) on a sun7410 ZFSSA (x4440 + j4400), but when I enable multipathing with "stmsboot -e", only the 1TB SATA drives inside the j4400 are configured as multipathed vhci / mpxio devices, but the logzillas / ZeusIOPS drives are skipped. the server is... (0 Replies)
Discussion started by: pressy
0 Replies
PODULEBUS(4)						   BSD Kernel Interfaces Manual 					      PODULEBUS(4)

NAME
podulebus -- Acorn Expansion Card bus driver SYNOPSIS
podulebus0 at ioc0 bank 4 (NetBSD/acorn26) podulebus0 at root (NetBSD/acorn32) DESCRIPTION
The podulebus driver handles the expansion-card interface in Archimedes machines and their successors. This includes conventional expansion cards, mini expansion cards (as introduced in the A3000), network expansion cards (as introduced in the A3020), DEBI expansion cards (as introduced in the Risc PC), and Mk II network cards (also introduced in the Risc PC). Drivers for individual cards attach as children of the podulebus device. NetBSD includes several machine-independent expansion card device drivers. There are also some device drivers which are specific to NetBSD/acorn26 or NetBSD/acorn32. HARDWARE
The following devices are supported by NetBSD. SCSI interfaces asc Acorn AKA30, AKA31, and AKA32 SCSI expansion cards (NetBSD/acorn32). cosc MCS Connect32 SCSI interface (NetBSD/acorn32). csa Cumana 8-bit SCSI interface (NetBSD/acorn32). csc Cumana 16-bit SCSI interface (NetBSD/acorn32). hcsc HCCS 8-bit SCSI interface. oak Oak SCSI interface. ptsc Powertec SCSI interface (NetBSD/acorn32). sec Acorn AKA30, AKA31, and AKA32 SCSI expansion cards. Disk controllers dtide D.T. Software IDE controller. hcide HCCS IDE controller. icside ICS IDE controller (NetBSD/acorn32). rapide Yellowstone Educational Solutions RapIDE IDE controller (NetBSD/acorn32). simide Simtec IDE controller (NetBSD/acorn32). Network interfaces ea Atomwide A-10xx and Acorn AEH54 Ethernet cards (Ether3). eb Atomwide and ANT network-slot and Acorn AEH61 Ethernet cards (EtherB). eh i-cubed EtherLan 100-, 200- and 500-series, and Acorn AEH75, AEH77, and AEH79 Ethernet cards (EtherH) (NetBSD/acorn26). ei Acorn AKA25 Ethernet card (Ether1). ie Acorn AKA25 Ethernet card (Ether1) (NetBSD/acorn32). ne Various vaguely NE2000-compatible Ethernet cards (NetBSD/acorn32). Serial interfaces amps Atomwide multi-port serial interface (NetBSD/acorn32). SEE ALSO
acorn26/eh(4), acorn32/asc(4), acorn32/cosc(4), acorn32/csc(4), acorn32/ie(4), acorn32/ptsc(4), dtide(4), ea(4), eb(4), ei(4), hcide(4), ne(4), oak(4), sec(4) BUGS
Too few drivers are shared between NetBSD/acorn26 and NetBSD/acorn32. BSD
October 26, 2006 BSD
All times are GMT -4. The time now is 09:46 PM.
Unix & Linux Forums Content Copyright 1993-2022. All Rights Reserved.
Privacy Policy