hi everone
i am experiencing disconnectivity from storage to My database machines. i have doubt on my FC cards in my sparc T4-2 machines. i want to know how should i check from my solaris that whether the cards are ok or not because once the disks get disconnect from SAN so it come back again but till then my database instance get crashes. so i want to confirm from my machines that whether fiber cards is ok. i usually use
it always connected and says online
plz guide what else should i check , any commands etc
regards
Moderator's Comments:
It is a bit hard to understand your post when you do not check your spelling . Please use your in browser spell checker before posting.
Hi all,
I have a compatibly issues with a new hardware
My config is the following one :
Solaris 10
V490 Hardware
2 X HBA Qlogic 2310f cards
An HP EVA 5000 for storage ...
Veritas VxVM 4.1 MP1
When I reboot my server, VxVM is trying to mount/use the volume before it's... (0 Replies)
I need information what maximum error level on FC card need clasification of critical level (SAN mass storidge)
Please write screenshot from utility fcutil whith test option.
Pawel (0 Replies)
Hi,
I'm trying to determine which HBA cards are installed on my Solaris 10 (Sun-Fire-V240) machine.
The relevant data I have is below, but from it I cannot ascertain for sure if I have Emulex 10000 or 11000 HBA cards.
Can anyone suggest how to determine my HBA hardware ?
Thanks,
Ron.
... (3 Replies)
Hi,
I'm trying to determine which HBA cards are installed on my Solaris 10 (Sun-Fire-V240) machine.
The relevant data I have is below, but from it I cannot ascertain for sure if I have Emulex 10000 or 11000 HBA cards.
Can anyone suggest how to determine my HBA hardware ?
Thanks,
Ron.
... (4 Replies)
I installed a FC array for the first time and everything looks OK
in mpathadm, cfgadm, but I don't know what to do next.
# stmsboot -L
non-STMS device name STMS device name
------------------------------------------------------------------
/dev/rdsk/c2t1d0 ... (3 Replies)
Hi ,
I have wrtitten a C program that issues USCSICMD ioctl call to the tape devices attached on solaris sparc 10. I was able to get the required information from all SCSI tape devices attached using the utility. But, whenever it is run on FC attached tape drives , the program returns an error... (0 Replies)
Hello,
I am trying to set up Channel Bonding on a RHEL6 Virtual Box VM. I have 2 ethernet cards on the machine which are set up in Internal Network mode. I followed all the steps exactly as mentioned in the RHEL6 deployment Guide, but for some reason i think results are not correct. Here are my... (13 Replies)
Hi
I had power issue that affected a server, in which I had power ON the server SPARC T1-B3 running solaris 10.
After power on the system stops at ok prompt, them I issued the following commands:
{0} ok setenv auto-boot? false
auto-boot? = false
{0} ok reset-all
SPARC T3-1B,... (10 Replies)
Discussion started by: fretagi
10 Replies
LEARN ABOUT NETBSD
isapnp
ISAPNP(4) BSD Kernel Interfaces Manual ISAPNP(4)NAME
isapnp -- introduction to ISA Plug-and-Play support
SYNOPSIS
isapnp0 at isa?
An
isapnp bus can be configured for each supported ISA bus.
DESCRIPTION
NetBSD provides machine-independent bus support and drivers for ISA Plug-and-Play (isapnp) autoconfiguration of PnP-compatible devices on an
ISA bus.
SUPPORTED DEVICES
NetBSD includes machine-independent ISAPNP drivers, sorted by function and driver name:
SCSI interfaces
aha Adaptec AHA-154[02] SCSI interfaces.
aic Adaptec AHA-1520B SCSI interfaces.
Disk controllers
wdc Standard IDE and ATAPI drive controller.
Serial and parallel interfaces
com 8250/16450/16550-compatible ISA PnP serial cards and internal modems.
Network interfaces
an Aironet 4500/4800 and Cisco 340 series 802.11 interfaces.
ep 3Com 3c509B EtherLink III Ethernet interface.
le PCnet-PnP Ethernet interfaces based on the successor to the AMD LANCE chip.
ne NE2000-compatible Ethernet interfaces.
tr TROPIC based token ring interfaces.
Sound cards
ess ESS Technology derived PnP sound cards and devices.
guspnp Gravis Ultrasound PnP sound cards.
sb SoundBlaster, SoundBlaster 16, and SoundBlaster Pro sound cards.
wss Windows Sound System compatible cards, e.g., most of the cards with Crystal Semiconductor chips.
ym Yamaha OPL3-SAx sound cards.
Miscellaneous devices
pcic PCI PCMCIA controllers, including the Cirrus Logic GD6729.
ISA Plug-and-Play devices also have alternate ISA drivers with static ISA IO address configuration. These are listed in isa(4). The isapnp
bus ignores devices that have already been found and configured as isa(4) devices. The isapnp bus is only effective on machines which lack a
PnP BIOS, or on which the PnP BIOS has been disabled. The manual pages for each individual isapnp driver also list the supported front-ends
for other buses.
SEE ALSO aha(4), aic(4), an(4), com(4), ep(4), ess(4), guspnp(4), intro(4), isa(4), le(4), ne(4), pcic(4), sb(4), tr(4), wdc(4), wss(4), ym(4)HISTORY
The isapnp driver appeared in NetBSD 1.3.
BSD February 17, 1997 BSD