hi everone
i am experiencing disconnectivity from storage to My database machines. i have doubt on my FC cards in my sparc T4-2 machines. i want to know how should i check from my solaris that whether the cards are ok or not because once the disks get disconnect from SAN so it come back again but till then my database instance get crashes. so i want to confirm from my machines that whether fiber cards is ok. i usually use
Code:
fcinfo hba-port
it always connected and says online
plz guide what else should i check , any commands etc
regards
Moderator's Comments:
It is a bit hard to understand your post when you do not check your spelling . Please use your in browser spell checker before posting.
Hi all,
I have a compatibly issues with a new hardware
My config is the following one :
Solaris 10
V490 Hardware
2 X HBA Qlogic 2310f cards
An HP EVA 5000 for storage ...
Veritas VxVM 4.1 MP1
When I reboot my server, VxVM is trying to mount/use the volume before it's... (0 Replies)
I need information what maximum error level on FC card need clasification of critical level (SAN mass storidge)
Please write screenshot from utility fcutil whith test option.
Pawel (0 Replies)
Hi,
I'm trying to determine which HBA cards are installed on my Solaris 10 (Sun-Fire-V240) machine.
The relevant data I have is below, but from it I cannot ascertain for sure if I have Emulex 10000 or 11000 HBA cards.
Can anyone suggest how to determine my HBA hardware ?
Thanks,
Ron.
... (3 Replies)
Hi,
I'm trying to determine which HBA cards are installed on my Solaris 10 (Sun-Fire-V240) machine.
The relevant data I have is below, but from it I cannot ascertain for sure if I have Emulex 10000 or 11000 HBA cards.
Can anyone suggest how to determine my HBA hardware ?
Thanks,
Ron.
... (4 Replies)
I installed a FC array for the first time and everything looks OK
in mpathadm, cfgadm, but I don't know what to do next.
# stmsboot -L
non-STMS device name STMS device name
------------------------------------------------------------------
/dev/rdsk/c2t1d0 ... (3 Replies)
Hi ,
I have wrtitten a C program that issues USCSICMD ioctl call to the tape devices attached on solaris sparc 10. I was able to get the required information from all SCSI tape devices attached using the utility. But, whenever it is run on FC attached tape drives , the program returns an error... (0 Replies)
Hello,
I am trying to set up Channel Bonding on a RHEL6 Virtual Box VM. I have 2 ethernet cards on the machine which are set up in Internal Network mode. I followed all the steps exactly as mentioned in the RHEL6 deployment Guide, but for some reason i think results are not correct. Here are my... (13 Replies)
Hi
I had power issue that affected a server, in which I had power ON the server SPARC T1-B3 running solaris 10.
After power on the system stops at ok prompt, them I issued the following commands:
{0} ok setenv auto-boot? false
auto-boot? = false
{0} ok reset-all
SPARC T3-1B,... (10 Replies)
Discussion started by: fretagi
10 Replies
LEARN ABOUT NETBSD
podulebus
PODULEBUS(4) BSD Kernel Interfaces Manual PODULEBUS(4)NAME
podulebus -- Acorn Expansion Card bus driver
SYNOPSIS
podulebus0 at ioc0 bank 4
(NetBSD/acorn26)
podulebus0 at root
(NetBSD/acorn32)
DESCRIPTION
The podulebus driver handles the expansion-card interface in Archimedes machines and their successors. This includes conventional expansion
cards, mini expansion cards (as introduced in the A3000), network expansion cards (as introduced in the A3020), DEBI expansion cards (as
introduced in the Risc PC), and Mk II network cards (also introduced in the Risc PC). Drivers for individual cards attach as children of the
podulebus device.
NetBSD includes several machine-independent expansion card device drivers. There are also some device drivers which are specific to
NetBSD/acorn26 or NetBSD/acorn32.
HARDWARE
The following devices are supported by NetBSD.
SCSI interfaces
asc Acorn AKA30, AKA31, and AKA32 SCSI expansion cards (NetBSD/acorn32).
cosc MCS Connect32 SCSI interface (NetBSD/acorn32).
csa Cumana 8-bit SCSI interface (NetBSD/acorn32).
csc Cumana 16-bit SCSI interface (NetBSD/acorn32).
hcsc HCCS 8-bit SCSI interface.
oak Oak SCSI interface.
ptsc Powertec SCSI interface (NetBSD/acorn32).
sec Acorn AKA30, AKA31, and AKA32 SCSI expansion cards.
Disk controllers
dtide D.T. Software IDE controller.
hcide HCCS IDE controller.
icside ICS IDE controller (NetBSD/acorn32).
rapide Yellowstone Educational Solutions RapIDE IDE controller (NetBSD/acorn32).
simide Simtec IDE controller (NetBSD/acorn32).
Network interfaces
ea Atomwide A-10xx and Acorn AEH54 Ethernet cards (Ether3).
eb Atomwide and ANT network-slot and Acorn AEH61 Ethernet cards (EtherB).
eh i-cubed EtherLan 100-, 200- and 500-series, and Acorn AEH75, AEH77, and AEH79 Ethernet cards (EtherH) (NetBSD/acorn26).
ei Acorn AKA25 Ethernet card (Ether1).
ie Acorn AKA25 Ethernet card (Ether1) (NetBSD/acorn32).
ne Various vaguely NE2000-compatible Ethernet cards (NetBSD/acorn32).
Serial interfaces
amps Atomwide multi-port serial interface (NetBSD/acorn32).
SEE ALSO
acorn26/eh(4), acorn32/asc(4), acorn32/cosc(4), acorn32/csc(4), acorn32/ie(4), acorn32/ptsc(4), dtide(4), ea(4), eb(4), ei(4), hcide(4),
ne(4), oak(4), sec(4)BUGS
Too few drivers are shared between NetBSD/acorn26 and NetBSD/acorn32.
BSD October 26, 2006 BSD
01-23-2020
