There used to be a licencing application which was very popular with software vendors wanting licence control called FlexLM (standing for Flexible Licence Manager). This tied licence security to the MAC address of the network interface. A value was computed on the MAC address which is known as the Hostid.
If your server is running FlexLM it will have a process running the executable 'lmgrd'. See if you've got one of those.
Help, if possible.
In SCO Open Server with installation of two-channel RAID controller the following happens: on the channel 0 disk array is seen by an operational system, and on the channel 1 array is not seen (simultaneously). That is the operational system can not simultaneously use more than... (1 Reply)
Hi,
I have a server that I am adding a RAID that we purchased to. The server works fine. It is running Fedora 7 and is a Dell Precision 690.
When the RAID is attached, it boots up and says the following:
Controller Bus #00, Device#1F, Function#02: 00 Ports
No device found
AHCI BIOS not... (0 Replies)
I am planning on building a fedora box with raid controller (database server).
Is anybody done that ? also what kind of software do you need to backup and recover data. (1 Reply)
I need to put together a RAID1 file server for use by Windoze systems. I've built zillions of windows systems from components. I was a HPUX SE for a long time at HP, but have been out of the game for years.
I've got an old workhorse mobo FIC PA-2013 with a 450 MHz K6 III+ I could use, but I'd... (2 Replies)
Hi All
I have a Sun T2000 server. Couple of years ago I had configured and mirrored the boot drive with an other drive using hardware RAID 1 using raidctl command.
Following is the hardware RAID output.
root@oracledatabaseserver / $ raidctl
RAID Volume RAID RAID Disk... (0 Replies)
I just built a home computer with 3TB hard drives I wanted to set up in a RAID 5 and load Ubuntu server onto it.
The first thing I did was set up the drives in a RAID 5 using just the motherboard chipset software to do it, so a 'hardware' RAID basically.
I installed Windows first to see if... (2 Replies)
First time poster and a very new Unix user, so I'll just pre-apologize for stupid questions now.
Does anybody know of a good RAID 1 hard drive backup that is Unix friendly? I want to avoid any hardcore programming. Can you recommend both NAS and non-NAS options? I need to do nightly backups... (31 Replies)
We have a 3ware RAID server at work, and as the appointed systems administrator (by virtue of being the one with the most knowledge) I've taken on the job of maintaining it. I've installed smartmontools on it to keep an eye on the drives and run scans every day, and looking at the data from the... (0 Replies)
Discussion started by: Krendoshazin
0 Replies
LEARN ABOUT DEBIAN
mactelnet
MACTELNET(1) General Commands Manual MACTELNET(1)NAME
mactelnet - A tool for telneting via MAC addresses
SYNOPSIS
mactelnet [options] <MAC-Address|hostname>
DESCRIPTION
This tool enables you to telnet other RouterOS or MAC-Telnetd enabled devices. You can connect to either a hostname or a MAC address. If
specified, the hostname (identity) will be looked up via MNDP discovery.
OPTIONS
These programs follow the usual GNU command line syntax. A summary of options is included below.
-n Do not use broadcast packets. A tad less insecure but requires root privileges. This means that ethernet packets will have the
specified mac-address as the packet destination, instead of using the ethernet broadcast address.
-t Amount of seconds to wait for a response on each interface. If you have several network interfaces, this is the timeout value per
interface.
-u Specify username. Without this option, you will need to enter the username in a interactive prompt.
-p Specify password. Without this option, you will need to enter the password in a interactive prompt.
-h Show summary of options.
-v Show version of program.
SEE ALSO mndp(1), mactelnetd(1), macping(1).
AUTHOR
mactelnet was written by Hakon Nessjoen <haakon.nessjoen@gmail.com>.
This manual page was written by Hakon Nessjoen <haakon.nessjoen@gmail.com>, for the Debian project (and may be used by others).
February 27, 2011 MACTELNET(1)