USB-USB cable between linux and windows computers Post: 302449809

6 More Discussions You Might Find Interesting

1. Hardware

How to install a driver of my USB-A to Serial Cable

Hi Gurus of Unix Recently I install a OpenSolaris in My HP 530 In this moment want to install a USB-A to Serial Cable. Any guru can send a Link where I can use how reference. I want to configure a Router and my PC don't have any serial Port. My LapTOP only has USB ports. In this case I buy a...

2. Red Hat

Installing LINUX KS from USB

:confused:Hello All, We are trying to install RHEL6 via USB using KICKSTART installation. We had following configuration: Below is the entry of isolinux.cfg file : menu label ^Kickstart Installation:via USB kernel vmlinuz append initrd=initrd.img ks=cdrom:/ks.cfg Below is the entry...

3. Ubuntu

[SOLVED] Dual boot Windows 7 and Ubuntu on USB

I am trying to dual boot on an external USB 500GB drive using my laptop.I have Windows 7 installed and booting on 1st partition 230GB now as active primary, 2nd partition is 100GB as primary, and 3rd partition is 135GB as primary. I was intending on installing Ubuntu onto the 2nd partition. I read...

4. Filesystems, Disks and Memory

Can I create Windows repair software in USB rather than CD?

My CD drive isn't working. So, is there any way to create windows recovery/repair software in flash drive/usb. This is the s/w which we use if system fails to boot.

5. Boot Loaders

Can I test windows 7 repair usb even if windows is fine?

I successfully created a bootable windows 7 repair usb. Please clarify me: I rebooted my system via USB. windows repair window appeared. There were 5 options. I opted 'windows memory diagnostic' and it worked fine. There was an option named 'start up repair'. This option can be used if windows...

6. HP-UX

Configure X windows with both keyboard and USB barcode reader

Greetings. Seeking guidance on adding a USB barcode reader (BCR) to an HP c3750 workstation with HP-UX 11.11 which is essentially configuring X windows to accept input from both a primary keyboard and a secondary keyboard that happens to be the BCR. Historically, I have successfully added a BCR...

LEARN ABOUT NETBSD

ehci

EHCI(4) 						   BSD Kernel Interfaces Manual 						   EHCI(4)

NAME

     ehci -- USB Enhanced Host Controller driver

SYNOPSIS

     ehci* at cardbus? function ?
     ehci* at pci? dev ? function ?
     usb*  at ehci?

DESCRIPTION

     The ehci driver provides support for the USB Enhanced Host Controller Interface, which is used by USB 2.0 controllers.

     EHCI controllers are peculiar in that they can only handle the USB 2.0 protocol.  This means that they normally have one or more companion
     controllers (i.e., ohci(4) or uhci(4)) handling USB 1.x devices.  Consequently each USB connector is electrically connected to two USB con-
     trollers.	The handling of this is totally automatic, but can be noticed since USB 1.x and USB 2.0 devices plugged in to the same connector
     appear to connect to different USB busses.

SEE ALSO

     cardbus(4), ohci(4), pci(4), uhci(4), usb(4)

HISTORY

     The ehci driver appeared in NetBSD 1.6.

BUGS

     The support for hubs that are connected with high speed upstream and low or full speed downstream (i.e., for transaction translators) is lim-
     ited.

BSD
								   Aug 10, 2008 							       BSD