03-27-2010
10 More Discussions You Might Find Interesting
1. Linux Benchmarks
CPU/Speed: Xeon 2.4 GHz
Ram:2512M
Motherboard:
Bus:533 Mhz
Cache:
Controller:
Disk:
Load:
Kernel: RedHat AS 2.1 - 2.4.9-e.27smp
Kernel ELF?:
pgms:
BYTE UNIX Benchmarks (Version 3.11)
System -- Linux lnxdev 2.4.9-e.27smp #1 SMP Tue Aug 5 15:49:54 EDT 2003 i686 unknown
... (0 Replies)
Discussion started by: lescalp
0 Replies
2. AIX
Hello Gurus,
i'm quite new person in AIX world, actually i'm SAP consultant. But due to my job faced with AIX.
Trying to configure new server for installation SAP. We have 4 disks one of them (hdisk3) has VG rootvg. How i can extend rootvg with another disk?
i tried:
# extendvg rootvg hdisk0... (2 Replies)
Discussion started by: sapbcer
2 Replies
3. AIX
I have a 9111-520 (p5 520) that I inherited, on which I want to install AIX 5.3 or possibly 6.1.
I've installed AIX many times, on a variety of platforms, but this one isn't working for me. What I can't seem to figure out is how to set it up to boot the CD. I'm assuming there is something I... (2 Replies)
Discussion started by: thomn8r
2 Replies
4. Linux
Anyone can help me answer the question.
Why does they use Linux on IBM pSeries not AIX.
I can't understand why, cause AIX is the best supporting from IBM pSeries.
Tks you. (3 Replies)
Discussion started by: quan0509
3 Replies
5. Linux Benchmarks
CPU/Speed: 2x 3,06 GHz Xeon SL6VP
Ram: 2 GB SDRAM ECC Registriert
Motherboard: Tyan Thunder i7501 Pro (S2721-533)
Bus: 533 MHz
Cache: 512 KB
Controller: ICH3 IDE Controller
Disk: 20 GB Maxtor EIDE (2B020H1) UDMA/100
Load:
Kernel: Linux 2.6.26-2-686
Kernel ELF?: yes
pgms: gcc... (0 Replies)
Discussion started by: RudiTheStriker
0 Replies
6. AIX
Hello,
I installed PowerVM IVM Virtual I/O on P-550 but later found out that the machine isn't activated for CoD VET code for virtualization.
So when booted , it goes into OPEN Firmware
I/O Hosting requires a hosting partition boot not permitted exit called
> ok
Panel shows > IO... (3 Replies)
Discussion started by: filosophizer
3 Replies
7. AIX
Hidey Ho Folks,
Looking to buy a pServer for playing around with the IBM side of things. Looked around for a bit and notice that there is a significant price gap for the used 570's (Single Units) vs the 520's and 550's that folks are selling. Curious what to watch out for in either case? And... (6 Replies)
Discussion started by: Devyn
6 Replies
8. AIX
Solution found: dimm error!
:mad: (2 Replies)
Discussion started by: Linusolaradm1
2 Replies
9. AIX
Hello all, I am hoping someone can point me in the right direction here.
We had a machine running AIX 6.1 that someone completely corrupted, so we decided to re-load it from media. I was able to boot into DVD media, select options for complete (destructive) install, AIX standard, etc. The... (0 Replies)
Discussion started by: JamesNJ
0 Replies
10. AIX
Hi,
when I boot I get an E1DC error code. I've looked it up and it says that this error occurs during the firmware check. But the error is called "Dynamic Console Selection" .
1- Machine stopped at LCD led display = E1DC = CA00E1DC
E1DC Dynamic console selection. (maybe cable or keyboard)... (3 Replies)
Discussion started by: filosophizer
3 Replies
LEARN ABOUT NETBSD
urlphy
URL(4) BSD Kernel Interfaces Manual URL(4)
NAME
url -- Realtek RTL8150L USB Ethernet driver
SYNOPSIS
url* at uhub?
urlphy* at mii?
DESCRIPTION
The url driver provides support for USB Ethernet adapters based on the Realtek RTL8150L USB-ether bridge chip.
The url driver supports the following adapters:
CompUSA USBKR100
GreenHouse GH-USB100B
Melco Inc. LUA-KTX
Sitecom LN013
For more information on configuring this device, see ifconfig(8).
DIAGNOSTICS
url%d: watchdog timeout A packet was queued for transmission and a transmit command was issued, however the device failed to acknowledge the
transmission before a timeout expired.
url%d: no memory for rx list The driver failed to allocate an mbuf for the receiver ring.
SEE ALSO
arp(4), mii(4), netintro(4), usb(4), ifconfig(8)
HISTORY
The url device driver first appeared in NetBSD 1.6.
AUTHORS
The url driver was written by Shingo WATANABE <nabe@nabechan.org>.
BSD
September 18, 2006 BSD