ethernet down Post: 302273963

9 More Discussions You Might Find Interesting

1. UNIX for Dummies Questions & Answers

Ethernet

We are trying to Establish Network using Linux.Now we are facing the problem in configring Ethernet.In out network we are giving eth0 in server and activating it at the boot time,so it is activating as it is but when we define the Ethernet of node on server and allowing it to activate at boot time...

2. UNIX for Dummies Questions & Answers

Ethernet Initialisation

I am using Red Hat 7.1 . I have installed one Server and trying to make network installing workstations on other system of a network. The Ethernet of the server has been mounted and working properly. I am getting problem installing /mounting the Ethernet of the workstations .I have tryed this by...

3. Cybersecurity

Ethernet sniff.

I suspect that someone is using a sniffer on my Ethernet connection, OS X 10.3.9, DSL, ok, I'm in terminal using the "ifconfig" command > flags=8049<UP,LOOPBACK,RUNNING,MULTICAST>mtu 16384 right, it's not in "promiscuous mode", but i think it's Trojaned, can anyone point me in the...

4. UNIX for Advanced & Expert Users

Virtual Ethernet

I understand that one should setup virtual ethernet adapters in the lpars which is the best way for various lpars to communicate with each other - Does anyone have info on this or can point me to a doc that explains how to set this up?

5. IP Networking

ethernet card

What command do I use to show mw the ethernet card, I have tried ipconfig -a

6. Solaris

ethernet problem

Boot device: /pci@8,600000/SUNW,qlc@4/fp@0,0/disk@w500000e0103c3391,0:a File and args: SunOS Release 5.8 Version Generic_108528-29 64-bit Copyright 1983-2003 Sun Microsystems, Inc. All rights reserved. ifconfig: plumb: qfe2: Bad file number configuring IPv4 interfaces: eri0. moving addresses...

7. Solaris

ethernet

my solris box network is unreachable how to solve this ipaddress assiagning and entry in vi /etc/host how to solve network is unreachable

8. AIX

vio server ethernet to vio client ethernet(concepts confusing)

Hi In the vio server when I do # lsattr -El hdisk*, I get a PVID. The same PVID is also seen when I put the lspv command on the vio client partition. This way Im able to confirm the lun using the PVID. Similarly how does the vio client partition gets the virtual ethernet scsi client adapter...

9. Linux

ethernet bonding

I need to enable Ethernet Bonding on three systems, connected together via switch. What I tried ended up with failure, slaves cannot be detected n added to bon0. Here's what I did: created file /etc/modprobe.d/bonding.d and added the following to it: alias bond0 bonding options bonding...

LEARN ABOUT DEBIAN

bpqparms

BPQPARMS(8)						   Linux System Managers Manual 					       BPQPARMS(8)

NAME

       bpqparms - Configure BPQ ethernet devices.

SYNOPSIS

       bpqparms device [-a ethaddr] [-d ethaddr] [-vV]

DESCRIPTION

       Bpqparms  allows  the  setting  of  the	BPQ  Ethernet  options for a particular device. Each BPQ Ethernet device appears as a device named
       bpq0...bpqN which overlays the original Ethernet device, usually eth0...ethN. This device is an AX.25 device driver and allows AX.25 frames
       to be transmitted over an Ethernet to another machine using the same protocol. The default for the device is to send and receive BPQ Ether-
       net packets to the broadcast address. This program replaces the previous "axparms -dev" option.

OPTIONS

       -a ethaddr     Allows the setting of which ethernet address will be accepted by the BPQ Ethernet device.

       -d ethaddr     If specified on its own, will set the destination ethernet address will be used for transmitting and for	receiving  of  BPQ
		      ethernet packets. An address of "broadcast" sets it to the ethernet broadcast address.

       -v	      Displays the version number.

       -V	      The original version messages.

SEE ALSO

       ax25(4), axports(5), ifconfig(8).

AUTHOR

       Joerg Reuter DL1BKE <jreuter@poboxes.com>

Linux								 4 September 1996						       BPQPARMS(8)