7 More Discussions You Might Find Interesting
1. UNIX for Dummies Questions & Answers
Just wanted to understand what is the logic being used by Solaris(kernel) to transmit data/traffic on physical interfaces.
I have seen most of the time traffic is being sent to interface ce0 and sometime to ce1.
I have removed ip address from below command for some reason.
netstat -rn
... (3 Replies)
Discussion started by: nadeemahmed
3 Replies
2. Solaris
Hi Al,
In course of understanding networking in Solaris, I have these doubts on Interfaces. Please clarify me. I have done fair research in this site and others but could not be clarified.
1. In the "ifconfig -a" command, I see many interfaces and their configurations. But I see many... (1 Reply)
Discussion started by: satish51392111
1 Replies
3. Solaris
Hello,
I have a machine with Solaris 8, and it has multiple interfaces that are connected to the same network which means they all have metric 0 (1 hop) to the default gateway.
assume:
* e1000g0: 10.1.1.70
* e1000g2: 10.1.1.72
* e1000g4: 10.1.1.74
* e1000g5: 10.1.1.76
* gateway:... (11 Replies)
Discussion started by: aeg
11 Replies
4. Solaris
is it possible to add a user twice to solaris server with the same id? i have been added twice in the past week and that is messing up one application that i am using which authenticate against the os. (10 Replies)
Discussion started by: basel
10 Replies
5. Solaris
Hello All,
I have a requirement to add multiple virtual interfaces on a non-global zone (Solaris 10). The global zone is a 2 node Veritas Cluster Server. So, my question is do we have to make any modifications to the cluster config (which I think should not be the case)? Can anyone help with me... (11 Replies)
Discussion started by: mahive
11 Replies
6. Solaris
Solaris Guru's
What is the proper way to add routes in the routing table so after a node reboot the routes will not be lost.
I understand the /etc/defaultrouter for the default router
and the <route add> command but using this command routes will be removed once the node reboots.
Thanks (7 Replies)
Discussion started by: Brad_52000
7 Replies
7. UNIX for Dummies Questions & Answers
Hi,
I am trying to configure an ip address, netmask, and default gateway on my solaris machine. For example, in Linux I would do the following command:
#ifconfig eth0 xx.xx.xx.xx netmask 255.0.0.0
#add route or route add default xxx.xxx.xxx.xxx
In Solaris 10, I believe the commands are... (7 Replies)
Discussion started by: annointed3
7 Replies