9 More Discussions You Might Find Interesting
Just istalled Solaris 11.
Want to configure network interfaces and got some problems:
If i run ifconfig -a, i am getting 2 lo0 (loopback) interfaces and thats all.
I can't enable interface, can't list it, can't assign IP to it.
Can... (2 Replies)
Discussion started by: nypreH
I have a machine with Solaris 8, and it has multiple interfaces that are connected to the same network which means they all have metric 0 (1 hop) to the default gateway.
* e1000g0: 10.1.1.70
* e1000g2: 10.1.1.72
* e1000g4: 10.1.1.74
* e1000g5: 10.1.1.76
* gateway:... (11 Replies)
Discussion started by: aeg
I have installed two solaris boxes in an VM.
First box is 10-1
Has two interfaces and in connected briged to the lan an d connected internal to an virtual lan.
Second box is 10-2
Has one interface.
Now what I wanted to do is a setup so that 10-2 connects through 10-1 to the lan.... (3 Replies)
Discussion started by: jld
4. IP Networking
Right, i need to admit Im c4p on networking. I hate it, always have, always will. Here's my problem
Ive got 3 hosts. A B and C. I need to directly contact host C from host A, but at the moment I have to ssh on to B, to then ssh on to C.
so, I need to set up host b, to forward... (3 Replies)
Discussion started by: sbk1972
I have just installed Solaris 10 for x86. The install seemed to have worked fine, and I have configured my hostname and am able to login and do whatever. However, networking does not seem to have been installed. I have a router which assigns ip address via DHCP. I would have thought Solaris would... (5 Replies)
Discussion started by: Phobos
6. IP Networking
how do i make sure that the new routing should take effect on the os memory right away? what should i run after i add all the new "route add ....".
I have an example below:
bash-2.03# netstat -rn
Routing Table: IPv4
Destination Gateway Flags Ref Use Interface... (1 Reply)
Discussion started by: itik
may i know what is the command for configure
new ip, subnet mask and gateway ??
thanks .. (3 Replies)
Discussion started by: Farbegas
8. UNIX for Dummies Questions & Answers
I am attempting to configure my ethernet interface on a Sun Blade 1500. I am testing out my network interface my connecting a crossover cable from my blade to a windows box. I would like to assign an ip address of 10.0.0.2 to "bge0" and netmask of "255.0.0.0". I have typed the following:
... (1 Reply)
Discussion started by: annointed3
9. UNIX for Dummies Questions & Answers
Have a solaris 9 e420, one onboard nic.
Now I added a quad nic card.
I have never had more than a single interface.
Any help on setting this new card up?
PLease? ; thanks! (2 Replies)
Discussion started by: BG_JrAdmin