Bank-Verlag: Linux Migration and SAP System Operation by Pironet NDH - PresseBox (Pre
Bank-Verlag: Linux Migration and SAP System Operation by Pironet NDH PresseBox (Pressemitteilung)(abonnement), Germany - 25 minutes ago Whereas the server that was hitherto in use employed the Unix operating system, the new hardware runs under the Linux Distribution from Red Hat. ...
We would be migrating UNIX file system to Linux file system.
We do have many directory and sub directories with files.
after migrating unix to linux file system , i want to make sure all the files has been copied ? What would be the best approach to validate directory ,sub-directory and file... (1 Reply)
Am actually am new to the linux operating system and knda wana knw more about it.Please could u help me with some commands so i can start with that first.Really need your help (5 Replies)
Does anyone can write a thread to teach me how to install Windows 2000, RH Linux, and FreeBSD unix in one machine step by step? Or someone's already done with this topic? (1 Reply)
DH(4) Kernel Interfaces Manual DH(4)NAME
dh - DH-11/DM-11 communications multiplexer
SYNOPSIS
/sys/conf/SYSTEM:
NDH dh_units # DH11; NDH is in units of boards (16 each)
NDM dm_units # DM11; NDM is in units of boards (16 each)
/etc/dtab:
#Name Unit# Addr Vector Br Handler(s) # Comments
dm ? 170500 310 4 dmintr # dm11 dh modem control
dh ? 160020 320 5 dhrint dhxint # dh11 terminal mux
major device number(s):
raw: 3
minor device encoding:
bits 0017 specify line on DH unit
bits 0060 specify DH unit
bit 0100 specify RTS/CTS (``hardware'') flowcontrol
bit 0200 specifies non-blocking open (``CD always on'')
DESCRIPTION
A dh-11 provides 16 communication lines; dm-11's may be optionally paired with dh-11's to provide modem control for the lines. If there
are fewer dm-11's than dh-11's, the dm-11's are assumed to be paired with the first dm_units dh-11's.
Each line attached to the DH-11 communications multiplexer behaves as described in tty(4). Input and output for each line may indepen-
dently be set to run at any of 16 speeds; see tty(4) for the encoding.
Bit 0200 of the minor device number for DH lines may be set to say that a line is not properly connected, and that the line should be
treated as hard-wired with carrier always present. Thus creating the special character device node "3, 130" via mknod /dev/ttyh2 c 3 130
would cause line ttyh2 to be treated in this way. Bit 0100 of the minor device number enables RTS/CTS (also called ``hardware'') flow con-
trol. It is enabled by adding 64 to the minor device number: mknod /dev/ttyh2 c 3 194
The dh driver monitors the rate of input on each board, and switches between the use of character-at-a-time interrupts and input silos.
While the silo is enabled during periods of high-speed input, the driver polls for input 30 times per second.
FILES
/dev/tty[h-k][0-9a-f]
/dev/ttyd[0-9a-f]
/dev/MAKEDEV script to create special files
/dev/MAKEDEV.local script to localize special files
SEE ALSO tty(4), dtab(5), autoconfig(8)DIAGNOSTICS
dh%d NXM. No response from UNIBUS on a dma transfer within a timeout period. This has never been observed on a PDP-11 and is a carryover
from the VAX driver when it was ported. It is not serious.
dh%d %d overruns. The character input silo overflowed before it could be serviced. This message is only printed at line close time. It
is not serious but does indicate that the system was not able to keep up with the data flow.
3rd Berkeley Distribution May 31, 1997 DH(4)
