Solaris

Can you tell me how to capture the post output to a file or do I have to type it all into a file?
I have a console monitor but no null modem cable to attach to ttya

I set diag-switch? to true and diag-level to max powered off the machine and powered on and booted the box but did not see any output from POST???

You should do a reset-all from the OBP before you power off. Once the system return to ok prompt , verify the param again by using printenv and then use the power-off command. on again and try

post results - power on selftest passed

OK, by what means are you connected to the storage? fibre channel, scsi? does luxadm command works to detect the disks? firmware updated , if you're using the HBA card?

I have an hba card and connect via scsi cable
I will run the luxadm command and get back to you

modinfo |grep FC
26 1289698 25070 118 1 ssd (SCSI SSA/FCAL Disk Driver 1.513)
27 12a69f8 192a0 103 1 fcp (SunFC FCP v20070529-1.123)
28 12bef08 8c00 - 1 fctl (SunFC Transport v20070529-1.57)
29 12c6218 18bb8 99 1 fp (SunFC Port v20070116-1.73)
30 12de680 105518 130 1 qlc (SunFC Qlogic FCA v20071114-2.25)

luxadm probe
No Network Array enclosures found in /dev/es

Found Fibre Channel device(s):
Node WWN:20000004cf22dccd Device Typeisk device
Logical Path:/dev/rdsk/c1t1d0s2
Node WWN:20000004cf991719 Device Typeisk device
Logical Path:/dev/rdsk/c1t2d0s2

luxadm qlgc
Found Path to 1 FC100/P, ISP2200, ISP23xx Devices

luxadm -e port
/devices/pci@8,600000/SUNW,qlc@4/fp@0,0:devctl CONNECTED

Opening Device: /devices/pci@8,600000/SUNW,qlc@4/fp@0,0:devctl
Detected FCode Version: ISP2200 FC-AL Host Adapter Driver: 1.15 04/03/22
Complete