10 More Discussions You Might Find Interesting
1. HP-UX
Fast question: a bad reset put ilo ip to 127.0.0.1(!)
and now i cannot reach via network
Is possible to get ilo via serial using COM1/console?
I see three console ports on server back side
two are standard and one is reachable only with this cable...
403 Forbidden
but i don't have this... (0 Replies)
Discussion started by: Linusolaradm1
0 Replies
2. UNIX for Dummies Questions & Answers
Hi,
I have Redhat Linux 5.9. I need to connect all the ILO to different switch which can support 1 Gig. How can I find if ILO port can support gigabit?
I am on HP website but not able to find anything about this information. Not sure I am looking in the correct place.
Please help. (3 Replies)
Discussion started by: samnyc
3 Replies
3. IP Networking
Hi, I have two questions about HP system iLO:
(1) The <HP iLO 2 User Guide> says "Configure the IP address: This step is necessary only if you are using a static IP address. When using dynamic IP addressing, your DHCP server will automatically assign an IP address for iLO 2. HP recommends using... (6 Replies)
Discussion started by: aixlover
6 Replies
4. Hardware
HI Guys
I have forgot my ILO password for REDHAT Linux, Its Protriat HP server.
I need to set new password for ILO without installing any RPM like "hponfig"....
I need to set password in terminal. please give me steps to change the password
waiting for ur replys (1 Reply)
Discussion started by: suresh_krish
1 Replies
5. Solaris
I have a brand new T5220 and I'm trying to configure the ILOM port with a static Ip address via the Serial Management port. I log on as "root" and then enter the commands ( see below) to config the port. When I enter the last command which is " set /SP/network commitpending=true", which I... (9 Replies)
Discussion started by: danfall4
9 Replies
6. HP-UX
how to set IP for iLO in HP server first time
thanks to all (1 Reply)
Discussion started by: sijocg
1 Replies
7. Linux
I have to write Linux script to findout what kind of ilo is been installed in the given ip address either ilo/LO100 or no device found.
IP address will be given in the command line of the script.
-> With out log on to the ip address, should get the ilo type installed in that machine.
1. I... (1 Reply)
Discussion started by: skmdu
1 Replies
8. HP-UX
Hi,
I wanted to setup a ilo for an HP 9000 rp 8420 server. Can anyone have an idea on it? (1 Reply)
Discussion started by: gunnervarma
1 Replies
9. Solaris
Greetings All,
If someone/anyone reading this post has had success setting up and configuring HP iLO2 CLI virtual serial port for Solaris...please tell how.
I'm trying to get a remote console to an HP DL385 server via iLO2 and ssh. The server is running Solaris 10 (11/06), patched to... (1 Reply)
Discussion started by: alias.256
1 Replies
10. UNIX for Advanced & Expert Users
I have an application that requires me to disable the restricted access to the X Server libraries by issuing the 'Xhost +' command from a Console Window.
It is important that this command is run from the Console Window and not a Terminal Window otherwise the system complains that DISPLAY is not... (0 Replies)
Discussion started by: jimthompson
0 Replies