9 More Discussions You Might Find Interesting
1. Solaris
Seems to wanboot ok but then fails to connect to server. What do I need to check?
{0} ok boot net - install
Boot device: /pci@300/pci@1/pci@0/pci@1/network@0 File and args: - install
1G link up
<time unavailable> wanboot info: WAN boot messages->console
<time unavailable>... (2 Replies)
Discussion started by: psychocandy
2 Replies
2. Ubuntu
I run lubuntu from usb (try lubuntu, it's not install on my pc )
And i try to connect to network
I see the network name
And i put the pass
But it's not connect..
I tried to open hot spot on my phone and try to connect and it's not connect
I have edumax n150
Try to install new driver -... (0 Replies)
Discussion started by: popcoern
0 Replies
3. UNIX for Dummies Questions & Answers
Have -
-3 HP Proliant G4P servers - Debian (wheezy)
-3 RaspPI's - Raspian
-Unmanaged switch that all 6 can ssh into each other with via eth0
-Router (w wifi and 5 ports) - on eth1 of the three G4p's of protocol dhcp
Want:
To let the six servers, in my basement run, since the HPs are... (5 Replies)
Discussion started by: sas
5 Replies
4. Shell Programming and Scripting
Hello all,
Here is the explanation of my problem:
I have a cronjob that connects to a NAS to do backups from my laptop to this NAS device.
The script that I wrote does check if there is a host (the NAS) responding on 192.168.1.10 and tries to connect to it with the following command:
mount -v... (3 Replies)
Discussion started by: freddie50
3 Replies
5. Solaris
I want to install Solaris 11 Express on my x86 system.
I'm facing network driver problems.
I've 3 network cards:
1. Intel(R) 82579V Gigabit Network Connection
In Device Driver Utility, This device is displayed as Ethernet controller, Driver is UNK and its highlighted in RED.
2. Belkin... (3 Replies)
Discussion started by: choudharypranay
3 Replies
6. Solaris
Hey Guys:
I am trying to add a route for assign a network interface to the traffic to/from a specific net, but allways to get the same system message : network is unreacheable
root@ColectorDMSCNT # route add net 200.44.46.0/24 161.196.84.196 1
add net 200.44.46.0/24: gateway... (2 Replies)
Discussion started by: aggadtech08
2 Replies
7. IP Networking
Hi.. I have problem about connecting two network. First let me tell about my project. I use Quagga to build up IPv6 Island Network. At first, i build one (1) PC Router or one (1) network, i call it as Network A. All PC's or Laptop's (node's) that connect to Network A can communicated to each other... (4 Replies)
Discussion started by: Lieyza
4 Replies
8. Filesystems, Disks and Memory
Hi,
I have a network disk that runs windows xp embedded. It doesnt support NFS.
But Samba is supported.
How do i connect to it through solaris 9. What are the steps required.
I have the IP address of the drive.
Thanks (1 Reply)
Discussion started by: R00tSc0rpi0n
1 Replies
9. IP Networking
I have a solaris 9 system that cannot get to the internet and cannot ping outside of the router. I can ping any other system on this campus but when i try to ping any other system outside of the campus im on i get unreachable.
Here is the systems info:
ip: 10.241.3.254
subnet: 255.254.0.0... (7 Replies)
Discussion started by: meyersp
7 Replies