3 More Discussions You Might Find Interesting
1. Fedora
How can I install netbeans on Solaris. Is there a package manager like yum for Fedora. I have tried pkg install netbeans, doesnt find it. Already preformed pkg install slim_install and it installed the jre. However if I run the sh file downloaded for netbeans it says no compatible JDK found.
Now... (2 Replies)
Discussion started by: Fingerz
2 Replies
2. Programming
When i write the source code in netbeans environment,if the source code,there are chinese characters,chinese characters will be displayed as box,how to solve this problem?please (2 Replies)
Discussion started by: fang_xiaoan
2 Replies
3. Filesystems, Disks and Memory
Wellcomes All,
some times ago I 've installed a Debian ditribution on an Hard Disk who was set as Primary Master. Few days ago, I 've decided to install another Hard Disk with a different Operating System. When I did that, I turned off the old hard disk, and I mouted the new one on the Primary IDE... (1 Reply)
Discussion started by: thekarsillo
1 Replies
LEARN ABOUT NETBSD
acardide
ACARDIDE(4) BSD Kernel Interfaces Manual ACARDIDE(4)
NAME
acardide -- acard IDE disk controllers driver
SYNOPSIS
acardide* at pci? dev ? function ? flags 0x0000
DESCRIPTION
The acardide driver supports the following IDE controllers:
Acard ATP850U Ultra33
Acard ATP860 Ultra66
Acard ATP860-A Ultra66
Acard ATP865-A Ultra100
It provides the interface with the hardware for the ata(4) driver.
The 0x0002 flag forces the acardide driver to disable DMA on chipsets for which DMA would normally be enabled. This can be used as a debug-
ging aid, or to work around problems where the IDE controller is wired up to the system incorrectly.
SEE ALSO
ata(4), atapi(4), intro(4), pci(4), pciide(4), wd(4), wdc(4)
BUGS
The timings used for the PIO and DMA modes for controllers listed above are for a PCI bus running at 30 or 33 MHz. This driver may not work
properly on overclocked systems.
BSD
October 24, 2003 BSD