Please post "iostat -En" output. I this SPARC hardware ?
Yes, it is SPARC.
Quote:
How much did this "Ooops!" cost the OP's employer?
$183 so far
Quote:
May be the OS is too old / unpatched. Since a 2010 update, ZFS is able to adjust most of such cases.
Solaris 10 implemented around summer of 2012
I have been advised by my Technical Assistance Center to buy a drive that has the same Sun/Oracle part number rather than the actual drive manufacturer's part number, like I thought I had done. The iostat output tells me that they are different though. They claim that despite the manufacturer, Seagate, Haitachi, etc, if the Sun part numner is the same then it will have the same geometry. Does this sound right?
Please help me!!!. I am new to Unix and I have to replace the tape backup drive. Originally the system had an IBM tape drive (Rhomat) that is damged. I changed it and installed a dat drive HP 5000+. The hardware recognize the drive, the diagnostics if OK. But when I try to install the operating... (3 Replies)
Hi folks,
I have the following configuration file:
tofu:/tmp # cat bitbandConfig.properties
maestroIp=10.10.10.10
maestroPort=2020
adminPlayPath=<Streaming Agent IP>:2021/streamingGateway/GetPlayList
###This part should not be changed###
adminPlayVODProtocol=http
username=iptv... (7 Replies)
My root disk is failed and how to replace the root disk in AIX.
Can u give a detailed explanation in step wise.
Pls give the answer taking different scenarios.
Regards
Praveen (1 Reply)
Any help appreciated
Sco Unix Ver 5.0+
Have 2 90 gig mirrored drives
Can these be replaced with any similar drive?
Can one just be replaced and will the mirror rebuild on it and then allow reboot on it ---then replace 2nd drive?
Thanks
pb (3 Replies)
I am trying to recover data off a drive that failed in my iMac. Apple returned the drive to me and I purchased a hard drive enclosure. I have been doing research on prices for data recovery services, way too expensive. I seen some links using Unix DD commands in the terminal none of which worked.... (6 Replies)
I am new to the AIX operating system and am seeking out some advice. We recently have had a drive go bad on our AIX server that is in a RAID 10 array. We have a replacement on the way. I was wondering what the correct steps are to swap out this drive. Does the server need to be powered off? Or can... (5 Replies)
I have a AIX 7.1 system that has 3 failed disks, 1 in rootvg and 2 in vg_usr1.
Here is the output of lspv.
# lspv
hdisk0 00044d4dfbb11575 vg_usr1 active
hdisk1 0000150179158027 vg_usr1 active
hdisk2 ... (11 Replies)
Discussion started by: c3rb3rus
11 Replies
LEARN ABOUT BSD
install-solaris
install-solaris(1M)install-solaris(1M)NAME
install-solaris - install the Solaris operating system
SYNOPSIS
install-solaris
install-solaris invokes the Solaris Install program. Depending on graphical capability and available memory at the time of invocation,
install-solaris invokes either a text-based installer or a graphical installer.
The following minimum requirements for physical memory dictate which features are available during installation:
For SPARC machines:
128 MB
Minimum physical memory for all installation types
128 MB
Minimum physical memory required for windowing system
384 MB
Minimum physical memory required for graphical-based installation
For x86 machines:
256 MB
Minimum physical memory for all installation types
256 MB
Minimum physical memory required for windowing system
512 MB
Minimum physical memory required for graphical-based installation
In some cases, even if the minimum physical memory is present, available virtual memory after system startup can limit the number of fea-
tures available.
install-solaris exists only on the Solaris installation media (CD or DVD) and should be invoked only from there. Refer to the for more
details.
install-solaris allows installation of the operating system onto any standalone system. install-solaris loads the software available on the
installation media. Refer to the for disk space requirements.
Refer to the for more information on the various menus and selections.
See attributes(5) for descriptions of the following attributes:
+-----------------------------+-----------------------------+
| ATTRIBUTE TYPE | ATTRIBUTE VALUE |
+-----------------------------+-----------------------------+
|Availability |SUNWcdrom (Solaris instal- |
| |lation media) |
+-----------------------------+-----------------------------+
|Interface Stability |Evolving |
+-----------------------------+-----------------------------+
pkginfo(1), install(1M), pkgadd(1M), attributes(5)
It is advisable to exit install-solaris by means of the exit options in the install-solaris menus.
23 Sep 2005 install-solaris(1M)