Need to configure my laptop Thinkpad - T430 as wifi hotspot
Hi All,
I have a Thinkpad - T430, which is having the wireless card as "03:00.0 Network controller: Intel Corporation Centrino Advanced-N 6205".
This one i need to configure as wifi hotspot. which i believe need to configure hostapd.conf, this kind of configuration is new to me anybody done it ?
Wireless card desc as below ..
Intel Corporation Centrino Advanced-N 6205
Subsystem: Intel Corporation Centrino Advanced-N 6205 AGN
Kernel driver in use: iwlwifi
Kernel modules: iwlwifi
Code:
root# iw phy0 info ( command iw output, which shows it's capable of AP-Access Point )
Wiphy phy0
max # scan SSIDs: 20
max scan IEs length: 223 bytes
Coverage class: 0 (up to 0m)
Device supports RSN-IBSS.
Supported Ciphers:
* WEP40 (00-0f-ac:1)
* WEP104 (00-0f-ac:5)
* TKIP (00-0f-ac:2)
* CCMP (00-0f-ac:4)
Available Antennas: TX 0 RX 0
Supported interface modes:
* IBSS
* managed
* AP
* AP/VLAN
* monitor
is there any body help me to achive this ? configure it as wifi hotspot.
Moderator's Comments:
Please use code tags next time for your code and data. Thanks
I am using Slackware 7 on my IBM Thinkpad. I am unable to configure it to display a graphical environment. Typing startx usually generates a few errors. The system, however, does boot into the shell environment without any issues or problems. I have been able to setup Slackware 7 successfully... (2 Replies)
I have in my possession an IBM Thinkpad 390X. I havebeen using word and lately a function delaing with the Fn button have created problems. It acts as if Fn is depressed though it is not. When I depress Fn I can type normally, the keys it affects are J,K,L,:,U,I,O,P,M,<,>,? Does anyone know how to... (0 Replies)
Hi gurus,
I am trying to connect to wifi access point with terminal, I set up my own access point (no encryption or MAC filters)
I ran followings commands
$ sudo iwlist eth1 scanning
eth1 Scan completed :
Cell 01 - Address: 00:11:2F:A2:99:1C
... (1 Reply)
Hi every body i m new using mandriva 2009 spring linux and i need to cofigure my wifi i have nexx card 54M 8085 it drivers in windows say realtec (1 Reply)
Hi to all,
I have the problem that a laptops with windows XP cannot startup even in safe mode nor using last good known configuration. I have a Ubuntu 10.10 Live CD and booting from it I can read the Hard Drive.
I need to do a backup the Hard Drive from XP laptop and I want to connect this... (5 Replies)
Is it possible to install Ubuntu 11.04 or Ubuntu 11.10 in Lenovo Thinkpad E520-1143 Now it Powerd By windowd Xp Professional is it possible to install Ubuntu in it and supports all drivers for ma laptop such as VGA driver Sound,Wireless,Lan , fingerprint,camera pls reply r is it possible to... (0 Replies)
Wireless adapter is intel so android client didn't connect to ubuntu hotspot. Ubuntu is failed so I want to install debian or suse on notebook for hotspot. Which one is the best for hotspot. :confused: (1 Reply)
Hi I have a new TP installed with RHEL 6.0, sound not working in this.
I tried to upgrade the kernel to 2.6.32-279.el6.i686 and also 2.6.32-279.19.1.el6.i686 but getting kernel panic with these kernels.
Any idea what is problem ???? (2 Replies)
Dear all,
I would like to transfer my old laptop documents/files etc to the new laptop without using any external hard disk.
Please let me know if its possible via any way.
Thank in advance,
emily (3 Replies)
Hi
This is a question about Broadcom BCM43225 wifi interface on an Acer Aspire laptop
I just had a fresh install of ubuntu 16.04 on my acer aspire laptop and I am having a difficult issue with my wifi connection. Every time I restart my laptop I get the wifi connection working, but after a... (0 Replies)
Discussion started by: faizlo
0 Replies
LEARN ABOUT FREEBSD
ixgbe
IXGBE(4) BSD Kernel Interfaces Manual IXGBE(4)NAME
ixgbe -- Intel(R) 10Gb Ethernet driver for the FreeBSD operating system
SYNOPSIS
To compile this driver into the kernel, place the following line in your kernel configuration file:
device ixgbe
Alternatively, to load the driver as a module at boot time, place the following line in loader.conf(5):
if_ixgbe_load="YES"
DESCRIPTION
The ixgbe driver provides support for PCI 10Gb Ethernet adapters based on the Intel 82598EB Intel(R) Network Connections. The driver sup-
ports Jumbo Frames, MSIX, TSO, and RSS.
For questions related to hardware requirements, refer to the documentation supplied with your Intel 10GbE adapter. All hardware requirements
listed apply to use with FreeBSD.
Support for Jumbo Frames is provided via the interface MTU setting. Selecting an MTU larger than 1500 bytes with the ifconfig(8) utility
configures the adapter to receive and transmit Jumbo Frames. The maximum MTU size for Jumbo Frames is 16114.
This driver version supports VLANs. For information on enabling VLANs, see ifconfig(8).
HARDWARE
The ixgbe driver supports the following cards:
o Intel(R) 10 Gigabit XF SR/AF Dual Port Server Adapter
o Intel(R) 10 Gigabit XF SR/LR Server Adapter
o Intel(R) 82598EB 10 Gigabit AF Network Connection
o Intel(R) 82598EB 10 Gigabit AT CX4 Network Connection
DIAGNOSTICS
ixgbe%d: Unable to allocate bus resource: memory A fatal initialization error has occurred.
ixgbe%d: Unable to allocate bus resource: interrupt A fatal initialization error has occurred.
ixgbe%d: watchdog timeout -- resetting The device has stopped responding to the network, or there is a problem with the network connection
(cable).
SUPPORT
For general information and support, go to the Intel support website at: http://support.intel.com.
If an issue is identified with the released source code on the supported kernel with a supported adapter, email the specific information
related to the issue to <freebsd@intel.com>.
SEE ALSO altq(4), arp(4), netintro(4), ng_ether(4), polling(4), vlan(4), ifconfig(8)HISTORY
The ixgbe device driver first appeared in FreeBSD 7.0.
AUTHORS
The ixgbe driver was written by Intel Corporation <freebsd@intel.com>.
BSD December 19, 2010 BSD
11-28-2014
