Sponsored Content
Full Discussion: Ftp is slow
Special Forums UNIX Desktop Questions & Answers Ftp is slow Post 302753271 by DGPickett on Tuesday 8th of January 2013 10:50:59 AM
Old 01-08-2013
Could be tcp tuning -- small mss means few packets can be sent before awaiting ack. The receiving system sends the buffer size as mss and that is all the sender can send ahead of ack'd byte sequence #. Often systems are defaulted to 4 512 byte packets, nice on a dialup but silly on Ethernet. Usually sending something like 1440-1460 bytes a packet allows for headers in the Ethernet MTU 1500, and the mss can be some large mutiple of that (to stifle small packets) under 65535, or more with rfc 1323. http://en.wikipedia.org/wiki/Transmi...l_Protocol#RFC

Last edited by DGPickett; 01-08-2013 at 11:56 AM..
 

9 More Discussions You Might Find Interesting

1. UNIX for Dummies Questions & Answers

slow ftp

On one of of solaris 7 boxes whenever i telnet or ftp it takes sometime before i get the prompt...any quick ideas where I should look...Thanks (3 Replies)
Discussion started by: suntan
3 Replies

2. Post Here to Contact Site Administrators and Moderators

Slow

The site has gone slow for quite some time... Can you do somethin abt it (2 Replies)
Discussion started by: DPAI
2 Replies

3. BSD

ipfw slow ssh and ftp connections

just as the title says. thanks. #General Rule Sets /sbin/ipfw add 0300 check-state /sbin/ipfw add 0301 deny tcp from any to any in established /sbin/ipfw add 0302 pass tcp from any to any out setup keep-state /sbin/ipfw add 0303 pass udp from any to any out #SSH FTP /sbin/ipfw add 0400... (11 Replies)
Discussion started by: dwildgoose
11 Replies

4. Solaris

Solaris 9 slow login thru ssh & ftp

When I ssh to my box, an Ultra 5. I get prompted for password immediately. I enter it and have to wait sometimes a full minute for it to prompt for a password. The same thing happens when i try to ftp to the box, it will say connected, but it takes forever to prompt for password, and... (2 Replies)
Discussion started by: BG_JrAdmin
2 Replies

5. UNIX for Dummies Questions & Answers

Slow FTP & SMB

SCO Unix 5.0.5 moving to Red Hat Intel EtherExpress Pro/100+ Newbie that just started working for a company and having an issue with transfer speeds over the network. Need to move 1.5GB of data from an old server with a single SCSI HDD to a new server with RAID 5 SATA HDD's. Goal was to FTP... (4 Replies)
Discussion started by: rockboles
4 Replies

6. UNIX for Dummies Questions & Answers

SSH and FTP connect slow

Hi again guys, Earlier today, just all of a sudden, all SSH and FTP connections to my internal Linux box just slowed down to a crawl. After the connection/authentication though, everything was back to normal speed. Until you have to connect again. A box reboot didnt work either. Now, from... (1 Reply)
Discussion started by: Aeros
1 Replies

7. Shell Programming and Scripting

FTP run from shell script gives slow transfer rates

Hey everybody, this is my first post so be gentle. I have two Sun 5220's running Solaris 10 that are directly connected with a cross-over cable at Gig. One of these boxes is my production Oracle server which generates a 50GB dump file every evening at 10:50. The other Solaris is a devolopment... (8 Replies)
Discussion started by: Countificus
8 Replies

8. IP Networking

Slow LAN FTP Transfers with FreeBSD...

Hello, I've got a FreeBSD 6 server running on my network that I used as a file server for my main computer. However I've really become frustrated with the slow up/down speeds I'm getting, about 100KB/s, which is about as bad as if I was using a "real" server. My setup is as follows: ISP |... (4 Replies)
Discussion started by: CyberCat
4 Replies

9. AIX

Slow FTP response on WAN

Hi All. We are using AIX 5.3 ML9. There is 1 Gig NIC installed on two servers (Primary and Secondary) with Full Duplex Mode. We have scheduled a cronjob to copy the backup from primary to secondary thru FTP on WAN. The total data size is 15 GB and it took 9 Hours and 18 Mins with transfer rate... (6 Replies)
Discussion started by: lodhi1978
6 Replies
spray(1M)                                                 System Administration Commands                                                 spray(1M)

NAME
spray - spray packets SYNOPSIS
/usr/sbin/spray [-c count] [-d delay] [-l length] [-t nettype] host DESCRIPTION
spray sends a one-way stream of packets to host using RPC, and reports how many were received, as well as the transfer rate. The host argu- ment can be either a name or an Internet address. spray is not useful as a networking benchmark, as it uses unreliable connectionless transports, UDP for example. spray can report a large number of packets dropped when the drops were caused by spray sending packets faster than they can be buffered locally, that is, before the packets get to the network medium. OPTIONS
-c count Specify how many packets to send. The default value of count is the number of packets required to make the total stream size 100000 bytes. -d delay Specify how many microseconds to pause between sending each packet. The default is 0. -l length The length parameter is the numbers of bytes in the Ethernet packet that holds the RPC call message. Since the data is encoded using XDR, and XDR only deals with 32 bit quantities, not all values of length are possible, and spray rounds up to the nearest possible value. When length is greater than 1514, then the RPC call can no longer be encapsulated in one Ether- net packet, so the length field no longer has a simple correspondence to Ethernet packet size. The default value of length is 86 bytes, the size of the RPC and UDP headers. -t nettype Specify class of transports. Defaults to netpath. See rpc(3NSL) for a description of supported classes. ATTRIBUTES
See attributes(5) for descriptions of the following attributes: +-----------------------------+-----------------------------+ | ATTRIBUTE TYPE | ATTRIBUTE VALUE | +-----------------------------+-----------------------------+ |Availability |SUNWrcmdc | +-----------------------------+-----------------------------+ SEE ALSO
rpc(3NSL), attributes(5) SunOS 5.10 6 Nov 2000 spray(1M)
All times are GMT -4. The time now is 06:12 AM.
Unix & Linux Forums Content Copyright 1993-2022. All Rights Reserved.
Privacy Policy