When I installed the SOLARIS 10 OS first time, the desktop would not start up, this was because of network setup. Reinstalled worked. After a week due to some problem I had to reinstall OS, installation went fine and but when i reboot I get this error.
cannot find mis/krtld
boot error loading... (0 Replies)
Hi
I hv try to install Solaris 9 on a SPARC machine. The machine now is with Solaris 10 OS.
I try to load a Solaris 9 installation cd in and use "boot cdrom" on ok promt, but it give me "no boot device found" when it boot up.
and when i use fsck, the system show me an error with the... (2 Replies)
Hi all ,
I have an E2900 SPARC IV that has Solaris 10 installed , I am trying to replace solaris 10 with soalris 9/04 , But the installation is giving me an error:
Cannot assemble drivers for root /ssm@0,0/pci@18,700000/pci@4/ide@2/cdrom@0,0:b
Cannot mount root on... (3 Replies)
I am trying to install Solaris x86 using the Jumpstart server. I run the add_install_client command with appropriate options, and reboot my x86 Target box. The installation starts fine and unattended. After the installation completes and the target goes for a re-boot, it does not boot from the HDD... (9 Replies)
I am trying to build a Sun Ultra 10 with solaris 10. This computer is one of a collection that was donated to the non-profic company I work for. All media was wiped before I recieved them, so I am starting from stratch.
I downloaded the Solaris 10 ISO and burned a DVD. The computer came with a... (4 Replies)
Hello,
I cant get my blade box to boot off the harddrive after installing solaris 10.I can get to a root prompt after issuing "boot cdrom -s".I tried booting off disk0 and disk1,but I get "the file just loaded does not seem to be executable".Thanks for any help.:wall: (4 Replies)
Hello,
I have a problem with my machine that won't boot properly.
The story is that I installed a software called apcupsd, which is a control application for my APC battery UPS. I have used version 3.14.10 earlier, but as part of restoring my previously crashed os harddrive I wanted to... (18 Replies)
Discussion started by: Zorken
18 Replies
LEARN ABOUT NETBSD
hptide
HPTIDE(4) BSD Kernel Interfaces Manual HPTIDE(4)NAME
hptide -- Triones/Highpoint IDE disk controllers driver
SYNOPSIS
hptide* at pci? dev ? function ? flags 0x0000
DESCRIPTION
The hptide driver supports the Triones/Highpoint HPT366, HPT370, HPT370A, HPT372 and HPT374 IDE controllers, and provides the interface with
the hardware for the ata(4) driver.
The 0x0002 flag forces the hptide driver to disable DMA on chipsets for which DMA would normally be enabled. This can be used as a debugging
aid, or to work around problems where the IDE controller is wired up to the system incorrectly.
SEE ALSO ata(4), atapi(4), intro(4), pci(4), pciide(4), wd(4), wdc(4)BUGS
The timings used for the PIO and DMA modes for controllers listed above are for a PCI bus running at 30 or 33 MHz. This driver may not work
properly on overclocked systems.
BSD October 8, 2003 BSD