Device eth0 issue Post: 302544749

5 More Discussions You Might Find Interesting

1. UNIX for Advanced & Expert Users

Eth err: "3c501 device eth0 does not seem to be present"

HI, When I do 'service network restart' , I am getting the following error. "3c501 device eth0 does not seem to be present, delaying initialization" Can any one suggest me the cause/solution for this? When I do 'lspci' it is showing the ehternet card as " Ethernet controller"Marvell...

2. AIX

How to find all device on p570 when need do device firmware upgrade?

I need upgrade firmware for the device of p570, when I go to IBM FIX download website, there are a lot of device of p570 listed. How can I know what device I have on my p570?

3. Solaris

Global device issue in sun cluster3.2

In my 2 node cluster (sun cluster3.2) running on x86 VMs. One of my nodes VM1 does not have the global devices populated due to which i cannot failover my file system to node VM1 , what could be the reason for this and how can i rectify it ? VM1:/>cd /dev/global -bash: cd: /dev/global: No...

4. Red Hat

Unable To Activate Ethernet Network Device in RHEL 5.5 - e100 device eth0 does not seem to be presen

Hi All, Could anyone please help to resolve the below problem. I installed RHEL5.5 in my desktop.But when i try to activate the ethernet connection then it gives me the error. I spent 2 days for the above and go through with several suggestion found by googling. But no luck. ...

5. HP-UX

Failed to open tape device /dev/rmt/0mn:Device busy (errno = 16)

Hi, Unable to make tape backup, please help. /opt/ignite/bin/make_tape_recovery -a /dev/rmt/?mn -I -v -m tar -x inc_entire=vg00 * Creating local directories for configuration files and archive. ======= 04/25/16 16:28:08 IST Started /opt/ignite/bin/make_tape_recovery. (Mon...

LEARN ABOUT OPENSOLARIS

liebert

LIEBERT(8)							    NUT Manual								LIEBERT(8)

NAME

       liebert - Driver for Liebert contact-closure UPS equipment

NOTE

       This man page only documents the hardware-specific features of the liebert driver. For information about the core driver, see nutupsdrv(8).

SUPPORTED HARDWARE

       This driver supports some Liebert UPS equipment with a contact-closure interface. This includes the UPStation GXT2 with their
       contact-closure cable. The smart mode ("Multilink") cable is not supported by this driver.

EXTRA ARGUMENTS

       This driver does not support any extra settings in the ups.conf(5).

BUGS

       This driver does not yet support shutdowns by raising DTR. Be aware that shutdowns are not possible with the stock contact-closure cable.
       You may have to build another cable with DTR connected through to the UPS for it to work.

       There is no way for this driver to detect the hardware or cable. It will start up successfully even if no UPS is present. This is a
       fundamental limitation of any contact-closure driver.

SEE ALSO

   The core driver:
       nutupsdrv(8)

   Internet resources:
       The NUT (Network UPS Tools) home page: http://www.networkupstools.org/

Network UPS Tools						    05/21/2012								LIEBERT(8)