10-17-2010
The zone is on a zfs filesystem so I think I'm good. So for the future, I need to create the zones on their own respective filesystems in order to snapshot them individually, correct?
6 More Discussions You Might Find Interesting
1. Solaris
Hi,
I have a primary/slave Bind 9 setup running on a Solaris 10 platform. Everything is hunky dorey, except for when I make a zone file change and up the serial the file that is transferred to the slave looses all its comments, and the entries are place in alphabetical order.
I administer many... (1 Reply)
Discussion started by: fulhamfcboy
1 Replies
2. Solaris
Hi Greetings...
I have an issue in connecting the zone from outside the network and it is because of default gateway. I can ping default gateway from inside the zone and not able to ping from global zone due to different VLAN issue. If i add two different gateways and restart network services,... (2 Replies)
Discussion started by: vvpotugunta
2 Replies
3. Solaris
I have two physical servers, with zones that mount local storage.
We were using "raw device" in the zonecfg to point to a metadevice on the global zone (it was not mounted in the global zone at any point).
It failed to mount on every boot because the directory existed in the zone.
I... (6 Replies)
Discussion started by: BG_JrAdmin
6 Replies
4. Solaris
can some one help me out as it is showing 2 different time zones in global zone and nonglobal zone .In global zone it is showing in GMT while in nonglobal zone i it showing as PDT.
System in running with solaris 10 (3 Replies)
Discussion started by: ravijanjanam12
3 Replies
5. UNIX for Advanced & Expert Users
Dear all,
recently, I migrated a solaris zone from one host to another. The zone was inside of a zpool. The zpool cotains two volumes.
I did the following:
host1:
$ zlogin zone1 shutdown -y -g0 -i0 #Zone status changes from running to installed
$ zpool export zone1
host2:
$ zpool... (2 Replies)
Discussion started by: custos
2 Replies
6. Solaris
Hi, hoping someone can help, its been a while since I used Solaris.
After creating a NGZ (non global zone), the NGZ can access the GZ (Global Zone) and the GZ can access the NGZ (using ssh, zlogin)
However, the NGZ cannot access any other netwqork devices, it can't even see the default router
... (2 Replies)
Discussion started by: GazinLincoln
2 Replies
LEARN ABOUT DEBIAN
local-filesystems
local-filesystems(7) Miscellaneous Information Manual local-filesystems(7)
NAME
local-filesystems - event signalling that local filesystems have been mounted
SYNOPSIS
local-filesystems [ENV]...
DESCRIPTION
The local-filesystems event is generated by the mountall(8) daemon after it has mounted all local filesystems listed in fstab(5). moun-
tall(8) emits this event as an informational signal, services and tasks started or stopped by this event will do so in parallel with other
activity.
This event is typically used by services that must be started in order for remote filesystems, if any, to be activated. Remember that some
users may not consider it wrong to place /usr on a remote filesystem. For most normal services the filesystem(7) event is sufficient.
This event will never occur before the virtual-filesystems(7) event.
EXAMPLE
A service that wishes to be running once local filesystems are mounted might use:
start on local-filesystems
SEE ALSO
mounting(7) mounted(7) virtual-filesystems(7) remote-filesystems(7) all-swaps(7) filesystem(7)
mountall 2009-12-21 local-filesystems(7)