Sponsored Content
Top Forums UNIX for Advanced & Expert Users Can You Mount FAT32 iSCSI Target in Solaris 10 (sparc)? Post 302460765 by radoulov on Thursday 7th of October 2010 01:52:26 PM
Old 10-07-2010
Please read the rules!
No duplicate posting!
Continue here.

Thank you!
 

9 More Discussions You Might Find Interesting

1. BSD

Mount Fat32,ext3

Hello All, How can i mount ext3 and Fat partition in FreeBSD 6.0 (0 Replies)
Discussion started by: jaibw
0 Replies

2. Solaris

How can I mount a ufs filesystem on a solaris 10 sparc onto a Linux server

Hi there, I am trying to mount a SAN volume (which is mapped to solaris sparc) partitioned with ufs filesystem onto a linux (intel processor 64bit) server. *I have re-compiled the linux kernel t support ufs fstype with ro mount support. filesystem on solaris:... (3 Replies)
Discussion started by: ilan
3 Replies

3. Solaris

Solaris 10 10/08 sparc + iSCSI

hi, I have installed Solaris 10 10/08 on sparc machine. I would like to configure iSCSI on that to mount SAN Volumes. Is there any need to install any additional patches for iSCSI to work. Thanks, Prashant. (4 Replies)
Discussion started by: prashantbhushan
4 Replies

4. Solaris

Iscsi - target + initiator on the same host.

Hi all iscsiadm / iscsitadm. Ive created two devices on a host. # iscsitadm list target Target: 1-disk0 iSCSI Name: iqn.1986-03.com.sun:02:f105ddf3-52a4-ed7a-9590-c3d354b8fc32.1-disk0 Connections: 1 Target: 1-disk1 iSCSI Name:... (0 Replies)
Discussion started by: sbk1972
0 Replies

5. UNIX for Advanced & Expert Users

LTO2 tape drive as iSCSI target

I'm using Bacula as my backup system, with full backups going to an LTO2 tape drive, while differentials and incrementals go to a disk array on my main server, babylon4. The tape drive is currently attached to a separate machine, because babylon4 does not have a SCSI controller, nor a free PCI-X... (0 Replies)
Discussion started by: Phil Stracchino
0 Replies

6. Solaris

Can You Mount FAT32 iSCSI Target in Solaris 10 (sparc)?

I get "mount: I/O error" when trying to mount an existing FAT32 iSCSI target. I also tried formatting the iSCSI target with fdisk and got fdisk: "Error in ioctl DKIOCSMBOOT" Details -- According to the format command, the whole disk is allocated to slice 6 and /dev/rdsk shows this as:... (0 Replies)
Discussion started by: ctafret
0 Replies

7. HP-UX

After adding new iscsi target port, still the session state of that target port is showing offline

Hi, I wanted to configure new iscsi port on HPUX system, i added the target port address and configured it, once done, went to array side and searched for that host iqn number , but was nt able to find the same, came to host, then when i ran "iscsiutil -pVS" command it gave me below result ... (0 Replies)
Discussion started by: Vinay Kumar D
0 Replies

8. HP-UX

Unable to delete iscsi target

Hi Please can someone give me a hint on this, when I list the targets, I see two o them: #iscsiutil -p Operational Target Information ------------------------------ Target # 1 ----------- Target Name : iqn.1992-08.com.netapp:sn.142241859 Target Alias ... (2 Replies)
Discussion started by: fretagi
2 Replies

9. Linux

How to boot iSCSI target from console linux?

I need boot any images from iSCSI and I'd like to boot from linux console of a previous LiveCD booted. Is possible, without gpxe, ipxe firmware or similar? With a simple iSCSI initiator for example? (1 Reply)
Discussion started by: spark2k06
1 Replies
iscsi(7D)																 iscsi(7D)

NAME
iscsi - iSCSI software initiator driver The iscsi driver is a software initiator that transports SCSI commands over TCP/IP as described in RFC 3720. The initiator is administered through iscsiadm(1M). The iscsi initiator acts as a host adapter driver that attaches the appropriate target driver (for example sd(7D) for disks or st(7D) for tapes) for devices it discovers. See the System Administration Guide for more information. /kernel/drv/iscsi 32-bit ELF kernel driver. /kernel/drv/sparcv9/iscsi 64-bit SPARC ELF kernel driver. /kernel/drv/amd64/iscsi 64-bit AMD64 ELF kernel driver. /kernel/drv/iscsi.conf Driver configuration file. /etc/iscsi/* iscsi persistent store. See attributes(5) for descriptions of the following attributes: +-----------------------------+-----------------------------+ | ATTRIBUTE TYPE | ATTRIBUTE VALUE | +-----------------------------+-----------------------------+ |Availability |SUNWiscsir, SUNWiscsiu | +-----------------------------+-----------------------------+ iscsiadm(1M), attributes(5) RFC 3720 Internet Small Computer Systems Interface (iSCSI) System Administration Guide: Devices and File Systems, Chapter 15 12 April 2005 iscsi(7D)
All times are GMT -4. The time now is 02:15 PM.
Unix & Linux Forums Content Copyright 1993-2022. All Rights Reserved.
Privacy Policy