Sponsored Content
Full Discussion: SUN Netra 240 Boot error
Operating Systems Solaris SUN Netra 240 Boot error Post 302426782 by ppandey21 on Thursday 3rd of June 2010 12:30:48 AM
Old 06-03-2010
SUN Netra 240 Boot error

Hi,

When I am trying to boot my SUN Netra 240 Machine its giving some boot error.

> {1} ok boot -i
Code:
> Boot device: /pci@1c,600000/scsi@2/disk@0,0:a File and args: -i 
> Boot load failed. 
> The file just loaded does not appear to be executable. 
> {1} ok

I tried to boot it from cdrom and monted the boot diskt to /a and tried

installboot to install bootblk. installboot and fsck ran fine and when I rebooted , it again gave the same error.

Just curious does this mean the disk is gone ? Below finding doesn't show any hard error though.

Pelase suggest

Code:
# iostat -En
c0t0d0           Soft Errors: 5 Hard Errors: 0 Transport Errors: 1
Vendor: TSSTcorp Product: CD/DVDW TS-L632D Revision: SI03 Serial No:
Size: 0.67GB <671088640 bytes>
Media Error: 0 Device Not Ready: 0 No Device: 0 Recoverable: 0
Illegal Request: 5 Predictive Failure Analysis: 0
c1t0d0           Soft Errors: 0 Hard Errors: 0 Transport Errors: 0
Vendor: FUJITSU  Product: MAX3147NCSUN146G Revision: 1503 Serial No: 0729G03TAW
Size: 146.80GB <146800115712 bytes>
Media Error: 0 Device Not Ready: 0 No Device: 0 Recoverable: 0
Illegal Request: 0 Predictive Failure Analysis: 0
c1t1d0           Soft Errors: 0 Hard Errors: 0 Transport Errors: 0
Vendor: FUJITSU  Product: MAX3147NCSUN146G Revision: 1503 Serial No: 0729G03T97
Size: 146.80GB <146800115712 bytes>
Media Error: 0 Device Not Ready: 0 No Device: 0 Recoverable: 0
Illegal Request: 0 Predictive Failure Analysis: 0


Thanks
Pradeep

Last edited by DukeNuke2; 06-03-2010 at 03:54 AM..
 

9 More Discussions You Might Find Interesting

1. Solaris

Netra 240 Hard disk are not detected

Hi All, I have new Netra 240 box which is not detecting its harddisk equiped with itse same har disk are detected when I swap with another machine. Same time If I swap hardisk of other machine to this Netra 240 box, also do not work. I have checked chassis, cabling etc and all looks fine. ... (1 Reply)
Discussion started by: xpwistler
1 Replies

2. Solaris

sun netra t1

so i've grabbed this sun netra t1 for some small dev work. now obviously i need to install sol10. no problem done it a million times except for the fact that i've never actually done it w/o a term server. so i grab a usb to serial and a serial to rj45 (the one you get in every cisco order.. roll... (24 Replies)
Discussion started by: pupp
24 Replies

3. Solaris

netra 240 difference

Hi, sunfire v240 and netra 240 are looks similar. system board, memory and processors are similar, then why netra 240 called as telco server? can anyone tell the difference. RJS (1 Reply)
Discussion started by: rajasekg
1 Replies

4. UNIX for Dummies Questions & Answers

Refurbished Netra 240 servers hangs after POST test

Hello everyone, I'm extremely new when it comes to SUN servers so bear with me and hopefully I can describe the issue I have accurately. At work we just received a refurbished SUN Netra 240 server. I was told to change some of the EEprom settings, and to do that I was to use a... (0 Replies)
Discussion started by: afferbwt
0 Replies

5. Solaris

Unable to access serial port from non-global solaris zone on netra 240

I am trying to use a serial communications device that is connected to /dev/ttyb on a netra 240 server. This is a solaris zone configuration using solaris 10 0910. I am able to access /dev/ttyb from the global zone but not throught he non-global zone. I have enabled all of the tty devices in my... (0 Replies)
Discussion started by: disagreeable
0 Replies

6. Hardware

POST displays error sparc netra 240

Hi guys, when I power on my sun netra 240 server, it displays these error messages: 1. Notice: cpu 0 has 2048/2048 MB of memory disabled. 2. Error : The following devices are disabled dimm1. Please can anyone be kind enough to explain this for me? Thanks (2 Replies)
Discussion started by: cjashu
2 Replies

7. Solaris

Fsck: alignment error Solaris 8, SUN Netra AX11505

Hello all, I recently powered on my Netra AX1105 server only to be greeted with the following error message. I am not sure what to do here, I cant fun fsck on OK prompt.. did ok>boot -r and now it keeps booting from net, then I run ok>boot disk then outputs the following message... and keeps... (3 Replies)
Discussion started by: br1an
3 Replies

8. Solaris

SUn Netra X4200 M2 Drivers

Hi Guys, Could someone please share the dvd/cd that came with server Netra x4200 M2 since it is not more available in Oracle site? Or do you know where I can get that? Thanks! (4 Replies)
Discussion started by: CristianS
4 Replies

9. Solaris

Fibre Channel link not ready on Netra 240

Hi, One of my Netra 240 went into hung state and I had to reboot it. I powered it off and tried booting it again but unsuccessful. It is not connected to SAN and have local disks. Not able to boot in failsafe mode too. There are two disks of 72GB, both are mirrored in SVM. It complains about... (5 Replies)
Discussion started by: solaris_1977
5 Replies
root_archive(1M)					  System Administration Commands					  root_archive(1M)

NAME
root_archive - manage bootable miniroot archives SYNOPSIS
/boot/solaris/bin/root_archive pack archive root /boot/solaris/bin/root_archive unpack archive root /boot/solaris/bin/root_archive packmedia solaris_image root /boot/solaris/bin/root_archive unpackmedia solaris_image root DESCRIPTION
The root_archive utility is used to manage bootable miniroot archives and is currently only available on x86 platforms. The utility can pack and unpack boot/root archives in both ufs and hsfs (iso9660) format. It will always generate ufs archives. root_archive also uses the lofi file driver to export a file as a block device (see lofi(7D)) and mount to mount or unmount file systems and remote resources (see mount(1M)). root_archive requires the same privileges that are needed to run these commands. SUBCOMMANDS
The root_archive command has the following subcommands: pack archive root Pack from the image found under the root directory to the archive. unpack archive root Unpack from the archive to an unpacked image under the root directory. packmedia solaris_image root Pack the solaris image to the root directory. unpackmedia solaris_image root Unpack the solaris image from the root directory. For packmedia and unpackmedia, other items that do not go into the ramdisk image are copied or uncopied (see cpio(1)) as well. Specifi- cally, this includes all the packaging databases needed for pkgadd and the other packaging utilities to succeed which are not used in the running and hence pruned to conserve memory. EXAMPLES
Example 1 Unpacking the Solaris x86 install image The following command unpacks the current Solaris image from the root directory: # root_archive unpackmedia /export/nv/solarisdvd.nvx_dvd/latest /export/Boot Where /export/nv/solarisdvd.nvx_dvd/latest represents a path to a Solaris x86 install image and /export/Boot is a directory that will be purged or created, as necessary. Example 2 Packing the Solaris x86 install image The following command packs the current Solaris image to the root directory: # root_archive packmedia /export/nv/solarisdvd.nvx_dvd/latest /export/Boot EXIT STATUS
The following exit values are returned: 0 The command completed successfully. 1 The command exited due to an error. ATTRIBUTES
See attributes(5) for descriptions of the following attributes: +-----------------------------+-----------------------------+ | ATTRIBUTE TYPE | ATTRIBUTE VALUE | +-----------------------------+-----------------------------+ |Availability |SUNWcsu | +-----------------------------+-----------------------------+ |Interface Stability |Stable | +-----------------------------+-----------------------------+ SEE ALSO
cpio(1), bootadm(1M), mount(1M), attributes(5), lofi(7D) SunOS 5.11 26 Sep 2005 root_archive(1M)
All times are GMT -4. The time now is 06:51 PM.
Unix & Linux Forums Content Copyright 1993-2022. All Rights Reserved.
Privacy Policy