pnmcut(1)                                                     General Commands Manual                                                    pnmcut(1)

NAME

       pnmcut - cut a rectangle out of a portable anymap

SYNOPSIS

       pnmcut  [-left  leftcol]  [-right  rightcol] [-top toprow] [-bottom bottomrow] [-width width] [-height height] [-pad] [-verbose] [ left top
       width height ] [pnmfile]

       All options may be abbreviated to the shortest unique prefix.

DESCRIPTION

       Reads a PBM, PGM, or PPM image as input.  Extracts the specified rectangle, and produces the same kind of image as output.

       There are two ways to specify the rectangle to cut: arguments and options.  Options are easier to remember and read, more  expressive,  and
       allow you to use defaults.  Arguments were the only way available before July 2000.

       If you use both options and arguments, the two specifications get mixed in an unspecified way.

       To  use  options, just code any mixture of the -left, -right, -top, -bottom, -width, and -height options.  What you don't specify defaults.
       It is an error to overspecify, i.e. to specify all three of -left, -right, and -width or -top, -bottom, and -height.

       To use arguments, specify all four of the left, top, width, and height arguments.  left and top have the same effect as specifying them  as
       the argument of a -left or -top option, respectively.  width and height have the same effect as specifying them as the argument of a -width
       or -height option, respectively, where they are positive.  Where they are not positive, they have the same effect as  specifying  one  less
       than  the  value  as  the argument to a -right or -bottom option, respectively.  (E.g.  width = 0 makes the cut go all the way to the right
       edge).  Before July 2000, negative numbers were not allowed for width and height.

       Input is from Standard Input if you don't specify the input file pnmfile.

       Output is to Standard Output.

OPTIONS

       -left  The column number of the leftmost column to be in the output.  If a nonnegative number, it refers to columns numbered from 0 at  the
              left, increasing to the right.  If negative, it refers to columns numbered -1 at the right, decreasing to the left.

       -right The column number of the rightmost column to be in the output, numbered the same as for -left.

       -top   The  row  number  of  the  topmost  row  to be in the output.  If a nonnegative number it refers to rows numbered from 0 at the top,
              increasing downward.  If negative, it refers to columns numbered -1 at the bottom, decreasing upward.

       -bottom
              The row number of the bottom-most row to be in the output, numbered the same as for -top.

       -width The number of columns to be in the output.  Must be positive.

       -height
              The number of rows to be in the output.  Must be positive.

       -pad   If the rectangle you specify is not entirely within the input image, pnmcut fails unless you also specify -pad.  In  that  case,  it
              pads  the output with black up to the edges you specify.  You can use this option if you need to have an image of certain dimensions
              and have an image of arbitrary dimensions.

              pnmpad can also fill an image out to a specified dimension, and gives you more explicit control over the padding.

       -verbose
              Print information about the processing to Standard Error.

SEE ALSO

       pnmcrop(1), pnmpad(1), pnmcat(1), pgmslice(1), pnm(5)

AUTHOR

       Copyright (C) 1989 by Jef Poskanzer.

                                                                   29 June 2000                                                          pnmcut(1)