I am not into Solaris but I know it from my Debian box. Maybe it helps so here you go:
I just had to make sure the USB kernel modules / drivers are there and then I just mount it to some mountpoint. It is not like that when I plug in the stick that there will be automatically be a device file created unter /dev. The needed device files are already there.
I just go on with
When plugged in, I get in /proc/bus/usb/devices following additional entry:
The other entries are about the controller etc.
Make sure that sda1 is not a partition or something of your other SCSI devices.
Hi...
question is this:
How do I mount an LVD hotswap scsi drive in bay #2 on a netra using the mount command? volmgt doesn't seem to mount it and/or I don't know how to view the drives data if it's formatted which it may not be. This drive is not new out of the box so I'm not sure.
... (4 Replies)
I am using Redhat 9 Linux, and am trying to get my external usb drive mounted (fat32). If I look at the KDE Control panel, it lists a usb 2.0 storage device under "USB Devices" (also in /proc/bus/usb), and under "SCSI" as scsi1. I looked at /proc/scsi/usb-storage-0, and it lists it there also. What... (6 Replies)
Dear All
Last day in Aix 5.2 server by executing
# df –g
I found following:
Filesystem GB blocks Free %Used Iused %Iused Mounted on
.
.
/dev/fslv00 58.00 136.70 -135% 212103 1% /sprod
After shutting down by following command
# shutdown –h
And when... (1 Reply)
Hi!
I have a problem with my disk, it is full as you can see
# df
Filesystem 1K-blocks Used Available Use% Mounted on
/dev/sda1 64380356 63125180 0 100% /
none 3116000 0 3116000 0% /dev/shm
/dev/sdb1 282015652... (10 Replies)
Hello Gurus!!
Very recently i tried to mount a USB pen drive onto my solaris 10 (X4170 model) server. As i understand, in ideal scenarios it should get mounted automatically, but it did not happen. Neither anything is shown in "iostat -En" output or "rmformat -l" about the pen drive.
I also... (10 Replies)
Hi,
I am facing issue with one of the drive is solaris 10. it is showing offline in the messages file
scsi: WARNING: /pci@2,600000/QLGC,qlc@0/fp@0,0/ssd@w5006016746e00b1b,0 (ssd0):
drive offline
genunix: WARNING: Page83 data not standards compliant DGC LUNZ 0430
... (1 Reply)
I have a Sun-Fire V440 running with Solaris 9 and am trying to get a WD USB Hard Drive mounted. None of the articles I've read so far have helped.
Output from rmformat:
Looking for devices...
1. Volmgt Node: /vol/dev/aliases/rmdisk0
Logical Node: /dev/rdsk/c5t0d0s2
... (17 Replies)
Discussion started by: oldtimertj
17 Replies
LEARN ABOUT REDHAT
hd
HD(4) Linux Programmer's Manual HD(4)NAME
hd - MFM/IDE hard disk devices
DESCRIPTION
The hd* devices are block devices to access MFM/IDE hard disk drives in raw mode. The master drive on the primary IDE controller (major
device number 3) is hda; the slave drive is hdb. The master drive of the second controller (major device number 22) is hdc and the slave
hdd.
General IDE block device names have the form hdX, or hdXP, where X is a letter denoting the physical drive, and P is a number denoting the
partition on that physical drive. The first form, hdX, is used to address the whole drive. Partition numbers are assigned in the order
the partitions are discovered, and only non-empty, non-extended partitions get a number. However, partition numbers 1-4 are given to the
four partitions described in the MBR (the `primary' partitions), regardless of whether they are unused or extended. Thus, the first logi-
cal partition will be hdX5. Both DOS-type partitioning and BSD-disklabel partitioning are supported. You can have at most 63 partitions
on an IDE disk.
For example, /dev/hda refers to all of the first IDE drive in the system; and /dev/hdb3 refers to the third DOS `primary' partition on the
second one.
They are typically created by:
mknod -m 660 /dev/hda b 3 0
mknod -m 660 /dev/hda1 b 3 1
mknod -m 660 /dev/hda2 b 3 2
...
mknod -m 660 /dev/hda8 b 3 8
mknod -m 660 /dev/hdb b 3 64
mknod -m 660 /dev/hdb1 b 3 65
mknod -m 660 /dev/hdb2 b 3 66
...
mknod -m 660 /dev/hdb8 b 3 72
chown root:disk /dev/hd*
FILES
/dev/hd*
SEE ALSO mknod(1), chown(1), mount(8), sd(4)Linux 1992-12-17 HD(4)