Hi,
I builded the linux kernel 2.6 with the following tool chain
binutils:2.16
gcc:3.4.4
glibc:2.3.5
kernel:2.6.10
and applied the corresponding patches to it.I got the kernel Image.I downloaded the Image on to the AT91RM9200 board.But when i am booting the image it is showing the... (1 Reply)
hello;
i'm trying to install a new kernel in fedora core 5 i'm using the following command:
/usr/src/linux-2.6.15.1# make && make modules && make modules_install && make install
but i always have the following error:
ld: édition de lien finale en échec: Aucun espace disponible sur le périphérique
... (1 Reply)
Hi All
Im trying to access the my windows XP NTFS from Redhat linux 4.0 Enterprise edition
I have downloaded the respective rpm
And im able to install it successfully
Then i have given the following command , but got an error
Here are my partitions
And when i give the below... (1 Reply)
Hi masters,
I am new to linux and unix forum and this is my first forum. So please excuse if
I am not giving sufficient information. I will give them on request.
I have created a bandwidth manager module. I am using a 2.6.9 kernel and in Red Hat 3.4.3 distribution. But when i run make... (1 Reply)
Hi all,
When i load my block device driver in Fedoracore10 kernel 2.6.27. i got this type of error kernel panic - not syncing : Fatal exception in interrupt. I am unable to save the log file....
Can any one help me.....
regards
sundar (4 Replies)
I have one big module 2.6.18 kernel mod.c
I want to divide this to several files.
The problem is to write right Makefile
lib1.h
lib1.c
mod.c
mod.c works fine normally but when I divide into several files
and try to compile with this makefile
obj-m := mod.o
mod-objs := lib1.o
... (3 Replies)
hello,everyone,I'm reading LDD3.Topics about oops,it said the code bellow would cause a fault condition because "this method copies a string to a local variable,unfortunately,the string is longer than the destination array".Well,hard to understand....Is that right?I thought the fault should be... (1 Reply)
please tell me the list of kernel parameters in RHEL 5.7
Because we've a requirement in one project.
Also tell me the importance of eah kernel parameter if possible.
==Thanks in Advance==:):D (1 Reply)
please tell me the list of kernel parameters in solaris10. Because we've a requirement in one project.
Also tell me the importance of eah kernel parameter if possible.
Thanks in Advance.:):cool: (2 Replies)
Discussion started by: vamshigvk475
2 Replies
LEARN ABOUT SUSE
hd
HD(4) Linux Programmer's Manual HD(4)NAME
hd - MFM/IDE hard disk devices
DESCRIPTION
The hd* devices are block devices to access MFM/IDE hard disk drives in raw mode. The master drive on the primary IDE controller (major
device number 3) is hda; the slave drive is hdb. The master drive of the second controller (major device number 22) is hdc and the slave
hdd.
General IDE block device names have the form hdX, or hdXP, where X is a letter denoting the physical drive, and P is a number denoting the
partition on that physical drive. The first form, hdX, is used to address the whole drive. Partition numbers are assigned in the order
the partitions are discovered, and only nonempty, nonextended partitions get a number. However, partition numbers 1-4 are given to the
four partitions described in the MBR (the "primary" partitions), regardless of whether they are unused or extended. Thus, the first logi-
cal partition will be hdX5. Both DOS-type partitioning and BSD-disklabel partitioning are supported. You can have at most 63 partitions
on an IDE disk.
For example, /dev/hda refers to all of the first IDE drive in the system; and /dev/hdb3 refers to the third DOS "primary" partition on the
second one.
They are typically created by:
mknod -m 660 /dev/hda b 3 0
mknod -m 660 /dev/hda1 b 3 1
mknod -m 660 /dev/hda2 b 3 2
...
mknod -m 660 /dev/hda8 b 3 8
mknod -m 660 /dev/hdb b 3 64
mknod -m 660 /dev/hdb1 b 3 65
mknod -m 660 /dev/hdb2 b 3 66
...
mknod -m 660 /dev/hdb8 b 3 72
chown root:disk /dev/hd*
FILES
/dev/hd*
SEE ALSO chown(1), mknod(1), sd(4), mount(8)COLOPHON
This page is part of release 3.25 of the Linux man-pages project. A description of the project, and information about reporting bugs, can
be found at http://www.kernel.org/doc/man-pages/.
Linux 1992-12-17 HD(4)