Sponsored Content
Full Discussion: netbeans IDE on Hp-UX
Operating Systems HP-UX netbeans IDE on Hp-UX Post 302195725 by domestos on Thursday 15th of May 2008 07:31:14 PM
Old 05-15-2008
netbeans IDE on Hp-UX

Can netbeans IDE be installed and used on hp-ux?

Sorry I know this is more java specific but does anybody have any experience with this? There does not seem to be any specific installation or support from netbeans.
 

3 More Discussions You Might Find Interesting

1. Filesystems, Disks and Memory

shift hard disk from primary IDE channel to secondary IDE channal

Wellcomes All, some times ago I 've installed a Debian ditribution on an Hard Disk who was set as Primary Master. Few days ago, I 've decided to install another Hard Disk with a different Operating System. When I did that, I turned off the old hard disk, and I mouted the new one on the Primary IDE... (1 Reply)
Discussion started by: thekarsillo
1 Replies

2. Programming

Netbeans ide can't display chinese character in linux

When i write the source code in netbeans environment,if the source code,there are chinese characters,chinese characters will be displayed as box,how to solve this problem?please (2 Replies)
Discussion started by: fang_xiaoan
2 Replies

3. Fedora

Installing netbeans

How can I install netbeans on Solaris. Is there a package manager like yum for Fedora. I have tried pkg install netbeans, doesnt find it. Already preformed pkg install slim_install and it installed the jre. However if I run the sh file downloaded for netbeans it says no compatible JDK found. Now... (2 Replies)
Discussion started by: Fingerz
2 Replies
ACARDIDE(4)						   BSD Kernel Interfaces Manual 					       ACARDIDE(4)

NAME
acardide -- acard IDE disk controllers driver SYNOPSIS
acardide* at pci? dev ? function ? flags 0x0000 DESCRIPTION
The acardide driver supports the following IDE controllers: Acard ATP850U Ultra33 Acard ATP860 Ultra66 Acard ATP860-A Ultra66 Acard ATP865-A Ultra100 It provides the interface with the hardware for the ata(4) driver. The 0x0002 flag forces the acardide driver to disable DMA on chipsets for which DMA would normally be enabled. This can be used as a debug- ging aid, or to work around problems where the IDE controller is wired up to the system incorrectly. SEE ALSO
ata(4), atapi(4), intro(4), pci(4), pciide(4), wd(4), wdc(4) BUGS
The timings used for the PIO and DMA modes for controllers listed above are for a PCI bus running at 30 or 33 MHz. This driver may not work properly on overclocked systems. BSD
October 24, 2003 BSD
All times are GMT -4. The time now is 06:46 PM.
Unix & Linux Forums Content Copyright 1993-2022. All Rights Reserved.
Privacy Policy