Sponsored Content
Full Discussion: netbeans IDE on Hp-UX
Operating Systems HP-UX netbeans IDE on Hp-UX Post 302195725 by domestos on Thursday 15th of May 2008 07:31:14 PM
Old 05-15-2008
netbeans IDE on Hp-UX

Can netbeans IDE be installed and used on hp-ux?

Sorry I know this is more java specific but does anybody have any experience with this? There does not seem to be any specific installation or support from netbeans.
 

3 More Discussions You Might Find Interesting

1. Filesystems, Disks and Memory

shift hard disk from primary IDE channel to secondary IDE channal

Wellcomes All, some times ago I 've installed a Debian ditribution on an Hard Disk who was set as Primary Master. Few days ago, I 've decided to install another Hard Disk with a different Operating System. When I did that, I turned off the old hard disk, and I mouted the new one on the Primary IDE... (1 Reply)
Discussion started by: thekarsillo
1 Replies

2. Programming

Netbeans ide can't display chinese character in linux

When i write the source code in netbeans environment,if the source code,there are chinese characters,chinese characters will be displayed as box,how to solve this problem?please (2 Replies)
Discussion started by: fang_xiaoan
2 Replies

3. Fedora

Installing netbeans

How can I install netbeans on Solaris. Is there a package manager like yum for Fedora. I have tried pkg install netbeans, doesnt find it. Already preformed pkg install slim_install and it installed the jre. However if I run the sh file downloaded for netbeans it says no compatible JDK found. Now... (2 Replies)
Discussion started by: Fingerz
2 Replies
IXPIDE(4)						   BSD Kernel Interfaces Manual 						 IXPIDE(4)

NAME
ixpide -- PCI IDE disk controllers driver SYNOPSIS
ixpide* at pci? dev ? function ? flags 0x0000 DESCRIPTION
The ixpide driver supports the ATI Technologies IXP IDE controller, and provides the interface with the hardware for the ata(4) driver. The 0x0002 flag forces the ixpide driver to disable DMA on chipsets for which DMA would normally be enabled. This can be used as a debugging aid, or to work around problems where the IDE controller is wired up to the system incorrectly. HARDWARE
The supported IDE controllers are o ATI SB200 o ATI SB300 o ATI SB400, Parallel ATA o ATI SB400, Serial ATA o ATI SB700, Serial and Parallel ATA SEE ALSO
ata(4), atapi(4), intro(4), pci(4), pciide(4), wd(4), wdc(4) CAVEATS
Some SB700 controllers can hang under load when Native IDE mode is selected in the system BIOS, but work fine in AHCI mode. BSD
October 16, 2008 BSD
All times are GMT -4. The time now is 06:17 PM.
Unix & Linux Forums Content Copyright 1993-2022. All Rights Reserved.
Privacy Policy