SEND(2) 							System Calls Manual							   SEND(2)

NAME

       send, sendto, sendmsg - send a message from a socket

SYNOPSIS

       #include <sys/types.h>
       #include <sys/socket.h>

       cc = send(s, msg, len, flags)
       int cc, s;
       char *msg;
       int len, flags;

       cc = sendto(s, msg, len, flags, to, tolen)
       int cc, s;
       char *msg;
       int len, flags;
       struct sockaddr *to;
       int tolen;

       cc = sendmsg(s, msg, flags)
       int cc, s;
       struct msghdr msg[];
       int flags;

DESCRIPTION

       Send, sendto, and sendmsg are used to transmit a message to another socket.  Send may be used only when the socket is in a connected state,
       while sendto and sendmsg may be used at any time.

       The address of the target is given by to with tolen specifying its size.  The length of the message is given by len.  If the message is too
       long to pass atomically through the underlying protocol, then the error EMSGSIZE is returned, and the message is not transmitted.

       No indication of failure to deliver is implicit in a send.  Return values of -1 indicate some locally detected errors.

       If  no  messages  space	is available at the socket to hold the message to be transmitted, then send normally blocks, unless the socket has
       been placed in non-blocking I/O mode.  The select(2) call may be used to determine when it is possible to send more data.

       The flags parameter may include one or more of the following:

	      #define  MSG_OOB	       0x1    /* process out-of-band data */
	      #define  MSG_DONTROUTE   0x4    /* bypass routing, use direct interface */
       The flag MSG_OOB is used to send "out-of-band" data on sockets that support this notion (e.g. SOCK_STREAM); the	underlying  protocol  must
       also support "out-of-band" data.  MSG_DONTROUTE is usually used only by diagnostic or routing programs.

       See recv(2) for a description of the msghdr structure.

RETURN VALUE

       The call returns the number of characters sent, or -1 if an error occurred.

ERRORS

       [EBADF]		   An invalid descriptor was specified.

       [ENOTSOCK]	   The argument s is not a socket.

       [EFAULT] 	   An invalid user space address was specified for a parameter.

       [EMSGSIZE]	   The socket requires that message be sent atomically, and the size of the message to be sent made this impossible.

       [EWOULDBLOCK]	   The socket is marked non-blocking and the requested operation would block.

       [ENOBUFS]	   The system was unable to allocate an internal buffer.  The operation may succeed when buffers become available.

       [ENOBUFS]	   The	output	queue  for a network interface was full.  This generally indicates that the interface has stopped sending,
			   but may be caused by transient congestion.

SEE ALSO

       fcntl(2), recv(2), select(2), getsockopt(2), socket(2), write(2)

4.2 Berkeley Distribution					   May 14, 1986 							   SEND(2)