08-12-2002
10 More Discussions You Might Find Interesting
1. UNIX for Dummies Questions & Answers
Pls help
i've used the boot assistance disk to boot my computer (P3 300)
after checking the drivers , i select the CD to install , however,
the computer said it can't mount the CD
CD is download from sun.com (solaris 8)
my CD rom is Misabushi and Ricoh (7060) ,
both cannot do so,
what is... (4 Replies)
Discussion started by: kazamih
4 Replies
2. UNIX for Dummies Questions & Answers
i am looking for video drivers for a hercules stingray 128/3d card running on an HP vectra with solaris i386 version 7. can anyone point me to a download? (1 Reply)
Discussion started by: thomasaowens
1 Replies
3. IP Networking
I have just installed solaris 8 for Intel on one of my machines at home and I have a cable modem connection with a static IP and I am using a linksys cable/dsl router to assign IP's to my machines. I was wondering if any of you guys know the specific files and examples of the files I have to... (2 Replies)
Discussion started by: reggie316
2 Replies
4. UNIX for Advanced & Expert Users
hi.
Have anyone use kde for solaris, if so can you help me download and configure it. i don't know which files i should download for solaris because there lots of files. Could you point me to the right path.thanks in advance. (9 Replies)
Discussion started by: souldier
9 Replies
5. Programming
hi I'm looking for a C Compiler that will run on a Solaris 8 (Intel) platform and that doesn't need to be complied.
I've tried gcc binaries but they don't seem to work.
Thanx. (5 Replies)
Discussion started by: ianf
5 Replies
6. Solaris
Hi im trying to install solaris 9 Intel and when i insert the installation cd, i run threw all the steps and when it goes and configure the system it fails with this error
cannot mount root on /pci@0,0/pci-ide@2.1/ide@1/sd@0,0"a fstype ufs
panic/thread=fec29020" vfs_mountroot: cannot mount... (1 Reply)
Discussion started by: dennisca
1 Replies
7. UNIX for Advanced & Expert Users
I was wondering what features are not available on Solaris installed on Intel architecture as compared to the SPARC archietecture??
:-) (3 Replies)
Discussion started by: encrypted
3 Replies
8. Solaris
Hello all mentor.
I am a new in this furom and also just self studying unix environment. :confused:
I have installed intel solaris 9 in my laptop and i have forgotten the root password nor maybe the numlock or capslock of the keyboard was enabled
during I enter the password installation... (3 Replies)
Discussion started by: eykyn17
3 Replies
9. Solaris
Hi All,
How can I go to OBP on Solaris 10-intel? I tried doing ctrl+c or ctrl+break, it won't go to the "ok" prompt.
Thanks in advance,
itik (6 Replies)
Discussion started by: itik
6 Replies
10. Solaris
just need help with loading solaris 10 from cds that i bought from sun. i have a dell box that had solaris 8 on it, wiped it and stuck in the cd1 for solaris 10. selected "solaris" for install. went through a few minutes then comes up with"sunOS Release 5.10 version generic_137138-09 32-bit,... (3 Replies)
Discussion started by: flir11
3 Replies
LEARN ABOUT DEBIAN
if_ixgb
IXGB(4) BSD Kernel Interfaces Manual IXGB(4)
NAME
ixgb -- Intel(R) PRO/10GbE Ethernet driver for the FreeBSD operating system
SYNOPSIS
To compile this driver into the kernel, place the following line in your kernel configuration file:
device ixgb
Alternatively, to load the driver as a module at boot time, place the following line in loader.conf(5):
if_ixgb_load="YES"
DESCRIPTION
The ixgb driver provides support for PCI Gigabit Ethernet adapters based on the Intel 82597EX Ethernet controller chips. The driver supports
Transmit/Receive checksum offload and Jumbo Frames.
For questions related to hardware requirements, refer to the documentation supplied with your Intel PRO/10GbE adapter. All hardware require-
ments listed apply to use with FreeBSD.
Support for Jumbo Frames is provided via the interface MTU setting. Selecting an MTU larger than 1500 bytes with the ifconfig(8) utility
configures the adapter to receive and transmit Jumbo Frames. The maximum MTU size for Jumbo Frames is 16114.
This driver version supports VLANs. For information on enabling VLANs, see ifconfig(8).
HARDWARE
The ixgb driver supports the following cards:
o Intel PRO/10GbE LR Server Adapter
o Intel PRO/10GbE SR Server Adapter
DIAGNOSTICS
ixgb%d: Unable to allocate bus resource: memory A fatal initialization error has occurred.
ixgb%d: Unable to allocate bus resource: interrupt A fatal initialization error has occurred.
ixgb%d: watchdog timeout -- resetting The device has stopped responding to the network, or there is a problem with the network connection
(cable).
SUPPORT
For general information and support, go to the Intel support website at: http://support.intel.com.
If an issue is identified with the released source code on the supported kernel with a supported adapter, email the specific information
related to the issue to <freebsdnic@mailbox.intel.com>.
SEE ALSO
arp(4), em(4), netintro(4), ng_ether(4), polling(4), vlan(4), ifconfig(8)
HISTORY
The ixgb device driver first appeared in FreeBSD 4.11 and FreeBSD 5.3.
AUTHORS
The ixgb driver was written by Intel Corporation <freebsdnic@mailbox.intel.com>.
BSD
August 18, 2006 BSD