8 More Discussions You Might Find Interesting
1. Infrastructure Monitoring
I'm trying to register & start a service using SMF on Solaris 10. It's nsca, part of the Nagios monitoring system. I've got nsca running fine as a detached process, and can manually create passive checks via send_nsca. But when I try to run nsca as a daemon, I need some advice.
The nsca... (0 Replies)
Discussion started by: lyle
0 Replies
2. AIX
Hello,
I have a quick question regarding POWER HA ( HACMP ) 5.5 ;
I have four ethernet adapters
en0
en1
en2
en3
en0 is configured as BOOT_IP with IP address
all other ethernet adapters are empty en1 / en2 / en3
so when I configure the service IP and start HACMP , the service IP... (2 Replies)
Discussion started by: filosophizer
2 Replies
3. UNIX for Dummies Questions & Answers
Hi gurus of Unix, I am newby in Unix, I need to Know the following.
How I know if SSH & Telnet service is UP in Solaris?
Please I appreciate your answer
Regard
Andres (2 Replies)
Discussion started by: andresguillen
2 Replies
4. UNIX Desktop Questions & Answers
I want to setup dual monitor for the Dell Optiplex Gx520 computer.
The motherboard has an Intel Corporation 82915G Integrated Graphics
Controller.
Then I add an ATI Rage 128 video card.
The dual monitor work on Windows 2000 with the Intel chip as the
primary screen and the ATI chip... (0 Replies)
Discussion started by: TsanChung
0 Replies
5. Windows & DOS: Issues & Discussions
Dear Sir / Madam,
With due respect, I am putting forwarad a question that whenever I am trying to check the current Service Pack & Hotfixes in Windows XP, I am getting the response like as under:
(Windows can't find the" qfecheck.exe " check it again) in GUI mode
... (1 Reply)
Discussion started by: swapan
1 Replies
6. Solaris
i had a toshiba laptop ( satellite L20 - 100) and i'm trying to install solaris 10 ...but it doesn't complete the setup from the very first begining
it gives me this msg:
unable to reset device //pci@0,0/pci1179,ff31@1d,2
can anybody help me installing solaris on the pc???
also can the... (2 Replies)
Discussion started by: slimydoom
2 Replies
7. SCO
Hi there guys and gals.
I have me a near new Toshiba eStudio 2500c.
I am having problems however.
i cannot print landscape? portrait comes out fine.
I have followed the Instructions on install to the letter.
when i print i try the following
lp -dToshibal -o LANDSCAPE... (6 Replies)
Discussion started by: togashiando
6 Replies
8. UNIX for Dummies Questions & Answers
I am trying to install mandrake 8.0 on my Satellite Pro 4600. I have got it installed but I am having problems with X windows. The laptop has a trident cyber blade video card I have it set to 1024x768 resolution Basically everytime I start x it appears in the upper right to middle of the screen... (6 Replies)
Discussion started by: gennaro
6 Replies