I think the processor supports it (Pentium D).
I'm sorry but I don't know how to read the dmesg output.
All i could do was this :
dmesg|grep acpi ---------- Post updated at 08:37 PM ---------- Previous update was at 08:34 PM ----------
Well, I followed the steps in the Debian wiki here to install the drivers for the following video card:
$ lspci | grep VGA
03:00.0 VGA compatible controller: NVIDIA Corporation GF104 (rev a1)I confirmed the correct driver is installed. As you probably see I've tried this a few times and a few... (1 Reply)
Hi,
I have a strange issue in my script.
When script is run from command prompt it runs fine,but when run from cron it exist with error message.
I narrowed down the issue and found that " use Mail::Sender;" is the culprit.
If I comment the statment the code runs fine in both command and... (9 Replies)
Hi masters,
I am new to linux and unix forum and this is my first forum. So please excuse if
I am not giving sufficient information. I will give them on request.
I have created a bandwidth manager module. I am using a 2.6.9 kernel and in Red Hat 3.4.3 distribution. But when i run make... (1 Reply)
I am using a SunBlade 100 system and accidently set a new alias for keyboard, now when it start it gives the following error,
The selected input device has no read routine. Keyboard not present using ttya for input and output.
Now i cannot execute any commands on the OBP and i just gets... (3 Replies)
I install a software xchm for opening chm files.
I install software and also its required libraries. But when i start it; no GUI appears. Application got halt. Process name also appears in process list when i run top command. Appliation continously using cpu but no GUI appears. Please tell me... (7 Replies)
I'm having a major problem trying to load a LPAR.
I've got through the HMC and shutdown and then activated the LPAR and it only gets to the Operator Panel Value of 0517. Now from some research I've found that this is to do with loading the rootvg. ( I think )
On the actual terminal all I get is... (0 Replies)
i am studying a script which is used for data loading.
it has functions which deletes all the existing data before loading and then loads new fresh data.
but i am stuck up at function Replace into table ( col 1,col 2....)
Does this signify All Inserts. (1 Reply)
Hi there:
Thanks for clicking in first. I have a question here. I have a module that needs to be dynamically loaded when another piece of code needs it at runtime. I know that I will have to make a soname file before I can use it dynamically. My question is what commad I should use to make... (2 Replies)
have a azuse mother borad 1600Mhz ram 512 hd 40gb
will not install windows want to finish but will not take it! Is this
a hard ware problem or a virus i use av norton 2002 and nod32
think got a virus not shure xp will not load any more (2 Replies)