9 More Discussions You Might Find Interesting
1. UNIX for Dummies Questions & Answers
I have a RHEL 5 system with a bonded interface configure using only one network port (eth0). So I have config file for ifcfg-bond0 and ifcfg-eth. I'd like to configure eth5 to be the second SLAVE in the bond. My question is, after I modify ifcfg-eth5, can I add eth5 to the bond0 interface without... (1 Reply)
Discussion started by: westmoreland
1 Replies
2. Solaris
I've one Netra 240
After changing main board and system configuration card reader, Network is not accessible any more, Network interfaces are always UP and Running even when there is no cable connected to Network interfaces.
I tried to restart and plumb/unplumb with no luck.
ifconfig -a... (7 Replies)
Discussion started by: samer.odeh
7 Replies
3. IP Networking
Hello,
Please, how can i create a network interface with a routable IP address on linux (ubuntu) ?
AND
How can i desactivate an interface?
Thank you so much for help. (1 Reply)
Discussion started by: chercheur857
1 Replies
4. IP Networking
Hello,
Please what's the difference between:
AND
Thank you so much (3 Replies)
Discussion started by: chercheur857
3 Replies
5. Solaris
i need to configure a zone to use different interface (bge2) than global and have connected to completely different network switch & to use its own defaultrouter and hosts file .. is it possible ..if so ..how ?
Thanks (9 Replies)
Discussion started by: skamal4u
9 Replies
6. Solaris
HI,
genunix: NOTICE: ce0: xcvr addr:0x01 - link up 100 Mbps half duplex
genunix: WARNING: ce0: fault detected external to device; service degraded
genunix: WARNING: ce0: xcvr addr:0x01 - link down
genunix: NOTICE: ce0: fault cleared external to device; service available
genunix: ... (4 Replies)
Discussion started by: sunnybee
4 Replies
7. UNIX for Advanced & Expert Users
Hi all,
I'm using an HP Proliant server with double NIC and Debian 5 (Lenny) as its OS. I used link bonding on it for several years with no problem.
Today, (now only one interface connected to switch) the interface went down. I restarted networking service (/etc/init.d/networking restart) and... (7 Replies)
Discussion started by: mjdousti
7 Replies
8. AIX
Hi every body,
I have a Fiber Channel interface (fcs2) in AIX 5.2. This interface was fine & up but for some reason I could not return this interface UP again after I set it DOWN.
When I tried to set this interface UP I encountered the following error:
Method error... (7 Replies)
Discussion started by: aldowsary
7 Replies
9. UNIX for Dummies Questions & Answers
Hi !
Does anyone know how can i get information about my network interface ... if it works in half or full duplex mode !!
Thx in adivance !
Witt (4 Replies)
Discussion started by: witt
4 Replies
ISIBOOTD(8) BSD System Manager's Manual ISIBOOTD(8)
NAME
isibootd -- TRFS based network boot server
SYNOPSIS
isibootd [-d tracelevel] [-i interface] [-s directory]
DESCRIPTION
The isibootd command is a server which supports OMRON LUNA's network boot protocol based on the Transparent Remote File System (TRFS) proto-
col. The TRFS protocol uses special Ethernet type packets and works within a local network.
isibootd is a simple TRFS server that only supports client reads for booting and exports files in a specified directory. isibootd accepts
requests only from clients listed in the /etc/ethers and have valid hostnames.
The options are as follows:
-d tracelevel
Run isibootd in debug mode with specified tracelevel. The tracelevel can be value 1, 2, or 3, and greater tracelevel provides
more detailed trace output. The server will not fork in the debug mode.
-i interface
Specify a network interface to service network boot. If not specified isibootd searches available network interfaces (excluding
loopback) and use the first configured ``up'' one.
-s directory
Specify a directory containing boot files to be served by isibootd. If not specified isibootd uses /tftpboot by default.
FILES
/etc/ethers
/etc/hosts
/tftpboot
/var/run/isibootd.pid
SEE ALSO
ethers(5), hosts(5), tftpd(8)
http://www.NetBSD.org/ports/luna68k/install.html
HISTORY
isibootd is based on isiboot utility which was originally written by Tohru Nishimura for NetBSD/luna68k development, and first appeared in
NetBSD 6.0.
BSD
December 15, 2011 BSD