remember that under ubuntu, Network-manager manages networks. If you want to do it manually, first stop network-manager:
then check your config in /etc/network/interface, then restart networking service:
ping the stack, if ok, then the gw, if ok, any ip over internet.
---------- Post updated at 10:49 AM ---------- Previous update was at 10:46 AM ----------
in your config, you may add dns information, that can help:
Hello!
Never configured a Linux server from a scratch.
Reviewed the official documentation and dozens of different "how to", but now one of them helped me to solve the issue.
The need:
My final goal is to install a small network (later with around 10 stations) where I can controle the... (0 Replies)
Hello, I am new to Ubuntu Server.
Can you please suggest very simple configuration to network.
Need:
1. Ubuntu Server (already installed)
2. Connect to it 1 Linux Mint computer (already installed) + 1 computer with Windows 7 (already installed).
Need to create 3 groups with... (2 Replies)
Hi,
I just upgrade my 11.04 to 11.10 last 2 days ang after i upgrade my system wont boot ang stay freezes forever in the logo with a msgs below state that the system will boot without network configuration. by the way before that happen the system show msgs about configure the network and again... (2 Replies)
I'm writing a program which uses curl to be run on Linux PCs which will be used by a number of different users. I cannot make the users all install curl on their individual machines, so I have tried to link curl in statically, rather than using libcurl.so. I downloaded the source and created a... (8 Replies)
Gurus,
I want log in locally to my Lucid (10.04) workstation and have my code saved over the network on my samba account
At work, all developers have samba user ids and when we were running Red Hat, we went thru the following procedure to get setup.
* open a shell session to NFS server... (2 Replies)
I have some static library(libxxx.a libyyy.a).
And I want to generate my library(libzzz.a), libzzz.a will use libxxx.a and libyyy.a
I wan't my application only use libzzz.a, (means libzzz.a had include libxxx.a, libyyy.a), how can I do that? Thank you.
example:
I have zzz.c.
I do ... (4 Replies)
Ubuntu version 8.10, Anjuta version 2.26.00. When load Anjuta a window shows up with the message "utility "" not installed. Please install it". What is this? Tried purge Anjuta amd remove autoremove using apt-get and re-install Anjuta but it doesn't solve my problem. How can i get rid off this... (0 Replies)
hello, i need help on setting my coyote linux, i've working on this for last 5 days, can't get it to work. I've been posting this message to coyote forum, and other linux forum, but haven't get any answer yet. Hope someone here can help me...... please see my attached picture first.
... (0 Replies)