other wise to do it manually its in some init script, youll just have to look for it, someone else here might chime in on where it is.
or, you could "duct tape" the problem...
just put
in a script and have that script run after the networking script has been run.
hint: you put the script in the /etc/rc.d directory, and symlinks to run the script in /etc/rc.d/rc$.d
where $ is the desired runlevel you want the script executed in.
edit: also, dont put it in the /etc/rc.d/network script, unless you know everything that script is doing.
one more thing, you dont need a symlink for that script to be run on shut down, only on start up, as the network script will take care of "shutting down" the networking settings.
Last edited by norsk hedensk; 09-21-2004 at 10:44 PM..
Hello,
here's my situation: I have a C++ server running on a well known machine and a number of Java clients running on other machines (assumed as unknown) on the same LAN. What I want to achieve is full duplex communication between those applications, in order to exchange complex objects and data... (3 Replies)
Hi,
How to find whether the server is running with half duplex or full duplex. I tried with the following command ndd -get /dev/ but am not getting any output,. Is the command correct?
Also let me know how to change from half to full duplex. (1 Reply)
I would like to change half duplex to full duplex on solaris 5.5. I tried with below commands but they didnt work on solaris 5.5.
#ndd -set /dev/le adv_100fdx_cap 1 (6 Replies)
I need to change some Ip addresses for my servers to reflect in the NIS map.
I also need to force full duplex on the 10/100 cards & 1/2 duplex in the 10 cards.
I can change the IP by doing ifconfig <NIC card > plumb up <newip>.
Not quite sure on how to force the full / half duplex & how to... (2 Replies)
All,
I have a RedHat 9 box which I need to figure out how to get it to stay in full duplex mode after a reboot.
I have tried
ethtool -s eth0 speed 100 duplex full autoneg off
I have tried to add a line to the /etc/sysconfig/network-scripts/ifcfg-eth0 like this:
ETHTOOL_OPTS="speed... (4 Replies)
Dear Members,
I was reading a few posts and saw something about installing two Nics so one could use Full Duplex. I remember back in the day of dial up, you could have two modems and use one for upstream and one for downstream. This was called shotgunning. It seems that you can now do the same... (4 Replies)
Ok at the moment I have a hub whit 5 computers connected to it. It's a 10/100 NetGear hub.
Ok I heard that there is some command I can run or a file I edit or something like that. But what the command/file/script/whatever does is tells you what connect speed it's connecting to the hub to.
... (4 Replies)
We are using ZIX 4.3.3 and we need to configure the NIC for ful duplexing and we also need to configure it for a TCP/IP default gateway and DNS server to acccess the Interent.
Can you please tell me the commands and procedures for configuring this?
Thanks
Marc (2 Replies)
We run Compaq UNIX Tru64 5.1.
After a switch got replaced our ethernet-card was magically set to
half duplex!
We saw, that the card was set to Autonegotiate:
vmunix: ee1: Autonegotiated, 100 Mbps full duplex
So we set the card with ifconfig to 100 Mbps full duplex with the
following... (3 Replies)