10 More Discussions You Might Find Interesting
1. Solaris
Our SunFire 480 - one of the boot disks failed. It is mirrored with VxVm. I followed the exact steps that is detailed in the veritas and sun guides (I can not post the URL since I don't have 5 posts yet.)
After removing the failed disk, I ran devfsadm -C -c disk and it still shows the device... (7 Replies)
Discussion started by: jtamminen
7 Replies
2. Solaris
hi all
when i trying to give auto-boot value as false as following
#eeprom auto-boot?=false
it is showing as
zsh: no matches found: auto-boot?=false
so felt this is because of error in hard ware so i tried this
#iostat -en
it is showing like
iostat -en
---- errors ---
s/w h/w trn... (4 Replies)
Discussion started by: wkbn86
4 Replies
3. Solaris
Hi all,
First post so be gentile :)
It's my first time installing Solaris on T2000 server.
I have 2 72GB HD's on it.
After configuring HW raid and running raidctl command I get this output:
bash-3.00# raidctl -l c0t0d0
Volume Size Stripe Status Cache RAID
... (2 Replies)
Discussion started by: Obi-Wan
2 Replies
4. Solaris
Hi All,
I recently had issues with my new T2000 server. I purchased a new mainboard and swapped the CPU and DIMMs to the new board. Now when i power on the server im unable to do so. I get the following error:
‘SC Alert: Host system poweron failed due to fault at MB/FF_POK.'
When i do... (2 Replies)
Discussion started by: Caully
2 Replies
5. Solaris
Hi All
I have a problem on T2000 server.
bash-3.00# uname -a
SunOS 5.10 aaa Generic_120011-14 sun4v sparc SUNW,Netra-T2000After the initial solaris installation server failed to boot:
Rebooting with command: boot
Boot device: disk:b File and args:
The file just loaded does not appear... (1 Reply)
Discussion started by: ouzist
1 Replies
6. Solaris
Hi, a couple of T2000 servers did not show the component status and the output was too short. There was a patch that needed to be installed. I also updated to the latest recommended patch cluster and OBP patch.
After reboot/restart of picl, it worked ok for a couple of weeks. Then suddenly it went... (12 Replies)
Discussion started by: incredible
12 Replies
7. Solaris
Hi,
I have a netra t2000 running solaris 10. It is fully patched with the latest patch cluster and also patch 118833-36 and 126897-02. The SC sys_event level is set to 3.
I am running a test to show hardware log status, e.g simulating a power supply failure.Hence I unplug one of te... (3 Replies)
Discussion started by: ulemsee
3 Replies
8. Linux
Hi frnds,
what is the devfsadm(solaris) equivalent command in linux os?
Thanks in Adv.
Arjun Reddy. (2 Replies)
Discussion started by: arjunreddy3
2 Replies
9. Solaris
I have an issue with DNS on a solaris t2000
When I set up the zones there was an issue with the /etc/resolv.conf, I had made a typo in my DNS server.
I only noticed this after creating my new zones.
I have corrected this in the global zone and I am now able to ping and nslookup inthe... (2 Replies)
Discussion started by: james dewitt
2 Replies
10. Solaris
Hi,
I have a T2000 box connected to very slow disks (EMC SAN ATA disks) by a double port hba through a fabric topology. RAID 5 (6+1) configuration.
The issue is using RMAN for backup and validation psent almost twice the time than with a V880 Fire connected the same way.
As with the... (2 Replies)
Discussion started by: freezer91
2 Replies