I tried prtconf but it shows nothing that looks like a network interface. I did install vmware tools and the installation went ok. But I still dont have any network interface.
Quote:
Originally Posted by DukeNuke2
maybe use solaris nevada... it has a better vmware support. Home at OpenSolaris.org
i never tried solaris 9 in vmware...
I have to use Solaris 9 cos I have to have the same environment as my real hardware for testing.
On the vmware side, I attached one host to host net iface which seems to be connected properly and I dont know what else I can change.
The .vmx file contains this section
Some people also say that I have to edit the .vmx file and add
I did it but then my VM fails to start saying
Quote:
Unable to change virtual machine power state; Check for missing file Dictionnary problem
yes, but he has no interface in his vmware environment. and also the "kstat -c net" shows only the loopback interface. so the problem ist not to find the interface. the problem is, there is NO interface
I have a RHEL 5 system with a bonded interface configure using only one network port (eth0). So I have config file for ifcfg-bond0 and ifcfg-eth. I'd like to configure eth5 to be the second SLAVE in the bond. My question is, after I modify ifcfg-eth5, can I add eth5 to the bond0 interface without... (1 Reply)
I've one Netra 240
After changing main board and system configuration card reader, Network is not accessible any more, Network interfaces are always UP and Running even when there is no cable connected to Network interfaces.
I tried to restart and plumb/unplumb with no luck.
ifconfig -a... (7 Replies)
Hello,
Please, how can i create a network interface with a routable IP address on linux (ubuntu) ?
AND
How can i desactivate an interface?
Thank you so much for help. (1 Reply)
Hi,
I'm a italian student. For my thesis I develop a gateway with protocol 6lowpan.
For that I must access to network interface to develope my personal stack based on standard 802.15.4.
Can you help me? I need an explanation for that. (0 Replies)
i need to configure a zone to use different interface (bge2) than global and have connected to completely different network switch & to use its own defaultrouter and hosts file .. is it possible ..if so ..how ?
Thanks (9 Replies)
Hi all,
I'm using an HP Proliant server with double NIC and Debian 5 (Lenny) as its OS. I used link bonding on it for several years with no problem.
Today, (now only one interface connected to switch) the interface went down. I restarted networking service (/etc/init.d/networking restart) and... (7 Replies)
Hi Gurus
Im a fresher and im working.I installed solaris 10 on my windows PC(dual boot) but im not able plumb my interface..everytime i use ifconfig command and tried different interfaces like eri0,ce0 etc but its displaying that interface not found.I know that there is some problem with... (15 Replies)
Hi all,
I just install solaris10 at home to learn b4 taking the sun courses. Can't get the internet on my IntelPC. I'm using cable thru SMC ezcard 10/100. I ran ifconfig -a and it only shows lo0. No hme0.
Pls help. (9 Replies)
Hi !
Does anyone know how can i get information about my network interface ... if it works in half or full duplex mode !!
Thx in adivance !
Witt (4 Replies)