10 More Discussions You Might Find Interesting
1. Solaris
Hi, Any help would be appreciated, when I attempt to install either OpenSolaris or Solaris 11 the install hangs right after the copyright where normally it would be "configuring devices" . If it is SOL 11 it just hangs if it is OpenSolaris it starts spitting out the following:
WARNING: hubdi:... (0 Replies)
Discussion started by: jk121960
0 Replies
2. Solaris
Hi ,
I have wrtitten a C program that issues USCSICMD ioctl call to the tape devices attached on solaris sparc 10. I was able to get the required information from all SCSI tape devices attached using the utility. But, whenever it is run on FC attached tape drives , the program returns an error... (0 Replies)
Discussion started by: naveen448
0 Replies
3. Solaris
Could anyone tell me where I can obtain Solaris 10 10/09 drivers for these divices listed below. I have looked in the OpenSolaris forums but I have not had any luck.
Device Vendor Device Name
Network Atheros AR928X Wireless Network Adapter (PCI-Express)
Storage Intel 82801 SATA... (4 Replies)
Discussion started by: Tenyhwa
4 Replies
4. Solaris
Hello all,
I'm having issue with trying to add device resource to my zone from the global zone.
I did the following
zoncfg -x larryase
add device
set match="/dev/tty*"
end
I get device already set, but in me zone I don't see the device.
Is there a "reboot -- r" command for zones? or... (0 Replies)
Discussion started by: larryase
0 Replies
5. Solaris
Hi,
can anyone help in finding the hardware related details of I/O devices of remote solaris machine .Thanks in advance. (7 Replies)
Discussion started by: pratheepv
7 Replies
6. Solaris
I want to configure my Network card. On solaris 9 i386.
How to know the good Network device. I use prtconf
to display the device list. I'm searching the device name.
Like ifconfig device_name plumb
thanks you (2 Replies)
Discussion started by: simquest
2 Replies
7. UNIX for Dummies Questions & Answers
Hi there again,
Running Solaris 10 with built-in Java. Seems to compile and run fine.
Problem is: Say I want to see contents of current directory. In a shell, I'd just write "ls" and it outputs the content.
When I write a Java file, I have the following line:
System.out.println("ls");
... (1 Reply)
Discussion started by: EugeneG
1 Replies
8. UNIX for Dummies Questions & Answers
I've been looking in my /dev directory for my available devices to set up a printer and was expecting to see some lp or lpr devices using Solaris 8, but I do not see them so I'm a little confused?
Any help would be greatly appreciated. (2 Replies)
Discussion started by: jroglass
2 Replies
9. Solaris
i want to use the devfsadm command and understand its function (3 Replies)
Discussion started by: bondoq
3 Replies
10. Solaris
I'm trying to mirror 2 eide disks on a solaris 10 x86 system.
Im trying to use the prtvtoc | fmthard command to mirror the vtoc.
How do they represent the entire disk like in solaris 9 (c0t0d0s2 = entire device)
0. c0d0 <DEFAULT cyl 26497 alt 2 hd 16 sec 63>
... (1 Reply)
Discussion started by: BG_JrAdmin
1 Replies