9 More Discussions You Might Find Interesting
1. Solaris
Hello there!
I am familiar with Linux, FreeBSD, but relatively new to Solaris. Because I wanted to play a little with servers and networks, I got a used SunFire v20z with AMD Opteron processors and installed OpenIndiana 151a8 on top of that. This is the first machine of this kind I have ever... (1 Reply)
Discussion started by: guru987
1 Replies
2. Hardware
Hello,
I am trying to perform Suse 10 SP3 installation via network in 6 Sun Fire 4270 M2 servers.
The problem is that even if i set first prio boot device the hard disk the system always try to boot from network.And after the first restart the BIOS setting has been lost(and PXE come first... (2 Replies)
Discussion started by: @dagio
2 Replies
3. Solaris
I have an old Sun SparcStation 5 that is running Sun OS 5.7, I'm not sure which commands would allow me to obtain the DNS zone transfer settings?
1.) I'm needing to know if the zone transfers are enabled.
2.) If it is enabled, does it transfer to specific servers
3.) If so, how do I go about... (1 Reply)
Discussion started by: Fhistleb
1 Replies
4. Solaris
Hi, I have a question, I have a legacy windows application that download files using FTP..The server previously was a Windows based server but it was upgraded to Sun Solaris 10. And that was when the application stopped working.
After a long time of troubleshooting, I might have found that the... (4 Replies)
Discussion started by: brian12988
4 Replies
5. Solaris
Hi All
How can we verify if any of the parameters we have change in Solaris10 after reboot. Like is there any command? Please advice
Thanks (3 Replies)
Discussion started by: imran721
3 Replies
6. Solaris
hi to all,
I am newuser can anyone tell me from where i get the sun solaris 10 dumps.
plz mail me at (no email addresses - read the RULES of these forums) (2 Replies)
Discussion started by: quickgun
2 Replies
7. Solaris
Hello All,
Please let me know how to order free sun sloaris10 dvd from sun microsystem?
Prashant (1 Reply)
Discussion started by: prashant_ohol
1 Replies
8. Windows & DOS: Issues & Discussions
I have a UNIX server w/an Adaptec aha-2740 card and i keep getting this error during post: EISA CMOS checksum error. It then tries to boot from the floppy. Upon researching this problem i found that it could be one of two things. Either it is the battery on the m/b (which i have all but ruled out),... (3 Replies)
Discussion started by: dlee35
3 Replies
9. UNIX for Dummies Questions & Answers
not entirely unix orientated but....
anyway i've got an old 486dx? 100 that i'll looking to turn into a unix running machine. But everytime i turn it on it comes up with and invalid CMOS checksum, after i've been into the set up and reset that it works fine, tried a new batter and that didn't sort... (1 Reply)
Discussion started by: stevox
1 Replies