10 More Discussions You Might Find Interesting
i have created a solaris zone but have not yet connected any network cables for this new zone,
can i set the zone up without running the command 'add net' and not adding an ip or physical interface?
i tried to add dummy internet settings and get this
zonecfg:coddr> add net... (4 Replies)
Discussion started by: newbiesolaris10
Hi, I have a question, I have a legacy windows application that download files using FTP..The server previously was a Windows based server but it was upgraded to Sun Solaris 10. And that was when the application stopped working.
After a long time of troubleshooting, I might have found that the... (4 Replies)
Discussion started by: brian12988
I have the following situation
1) Start JBoss Server 1
2) Within application - print as normal
3) Start JBoss Server 2
4) Printing STOPS on Server 1; Printing does NOT WORK on Server 2
Only solution is to stop Server 2;
Restart Server 1
Then Printing works as normal.
Doung a truss... (8 Replies)
Discussion started by: pmm
I am attempting to change the speed and duplex settings on a single interface on a bge card on an m3000 SPARC server. Currently the settings are as follows:
bge0 link: up speed: 1000 Mbps duplex: full
bge1 link: up speed: 100 Mbps ... (13 Replies)
Discussion started by: brialt1
5. IP Networking
I have a system which has been setup with a netmask of 255.255.252.0 . The customer says this netmask is wrong as is causing them some problems. They want me to change it too 255.255.254.0
So what would the command be for my bge0 port.
Can I do this whilst its running the software ?... (1 Reply)
Discussion started by: Maillot Jaune
When I log in from my linux workstation (CentOS4) to a solaris 8 server using SSH or telnet, the terminal settings don't seem to work well. When I tail or vi a file, I get a blank screen or no response, and I am no longer able to interact with the session. I have to type the escape sequence to... (2 Replies)
Discussion started by: tjlst15
7. Shell Programming and Scripting
I want develop a script which should also check validity of netmask.
How can I check which IP adresses are valid for this netmask?
I think the best is use logical operations.
224 is 1 1 1 0 0 0 0 0
so is valid from 10.15.20.31... (2 Replies)
Discussion started by: rhacodactylus
8. IP Networking
On our new Solaris machine I have set up a network card with an IP of 10.44.12.102 , netmask of 255.255.252.0 and broadcast 184.108.40.206. These are to match current configuration on the other servers (running an older Solaris).
However , after the machine is rebooted the ifconfig -a displays... (2 Replies)
Discussion started by: markdr011
How can I permenantly change the IP, netmask and default GW
for Linux server on Apatchi. (2 Replies)
Discussion started by: salhoub
10. UNIX for Dummies Questions & Answers
I am getting the following error when try to use vi
vt100: Unknown terminal type
Visual needs addressable cursor or upline capability
I have checked the TERM variable which is set to vt100. What could be the problem. This is on solaris 2.8 and i am doing telnet. (2 Replies)
Discussion started by: sssow