8 More Discussions You Might Find Interesting
1. IP Networking
My son does homework on a school laptop. I was thinking about setting up a gateway on my home network, so that I can monitor web traffic and know if he is doing his homework without standing over his shoulder. Ideally I would like to use the Raspberry Pi Model b that I already have. However, I... (15 Replies)
Discussion started by: gandolf989
15 Replies
2. UNIX for Advanced & Expert Users
Hi All,
I successfully configured a DEBIAN Lenny bridged firewall
using ebtables.
The bridged interface is br0.
The ethernet interface are eth0 & eth1 respectively.
All the traffic are transparently passing my firewall but i need to find & block temporarily the bandwidth abusers.
Can... (1 Reply)
Discussion started by: coolatt
1 Replies
3. Solaris
I have one disk that is reporting I/O errors but the same LUN mounted on a different node is able to access it without issue, is there a way to identify which HBA is being used for the LUN without swapping each out at a time? (4 Replies)
Discussion started by: thmnetwork
4 Replies
4. Red Hat
How to monitor network device traffic using MRTG?
How can I add network devices in MRTG configuration to monitor? (2 Replies)
Discussion started by: manalisharmabe
2 Replies
5. Solaris
Hello,
In Solaris 10 I can use fcinfo to find what speed the hba ports are running at, am I able to find this out using Solaris 9? I have tried a few variations on luxadm but cant find anything relevant.
Thanks. (1 Reply)
Discussion started by: Actuator
1 Replies
6. Solaris
Hi,
I'm trying to determine which HBA cards are installed on my Solaris 10 (Sun-Fire-V240) machine.
The relevant data I have is below, but from it I cannot ascertain for sure if I have Emulex 10000 or 11000 HBA cards.
Can anyone suggest how to determine my HBA hardware ?
Thanks,
Ron.
... (4 Replies)
Discussion started by: ronbarak
4 Replies
7. UNIX for Advanced & Expert Users
Hi,
I'm trying to determine which HBA cards are installed on my Solaris 10 (Sun-Fire-V240) machine.
The relevant data I have is below, but from it I cannot ascertain for sure if I have Emulex 10000 or 11000 HBA cards.
Can anyone suggest how to determine my HBA hardware ?
Thanks,
Ron.
... (3 Replies)
Discussion started by: ronbarak
3 Replies
8. Solaris
Hi ,
How can I collect information about any Hardware , specially HBA (Host Bus Adapter) ....
I tried prtdiag but it is not shoing the HBA details.
Regards (4 Replies)
Discussion started by: adel8483
4 Replies