I have a new SAN (Fujitsu Eternus 2000) and am trying to setup a veritas cluster on it, however veritas does not see all of the vluns I have exposed to the box. The OS does see them though. I have seen a lot of post about this, but it seems they are about people having just the opposite problem (seeing multiple disks). I only see two of the disks in vx but I see all nine in solaris.
I have nine volumes in a RAID1+0 group on the SAN.
There are two HBA ports, running to two different switches, that hit two interfaces on the SAN.
Im running Solaris10 and VCS5.0
Any idea what I am doing wrong ?
---------- Post updated at 03:10 PM ---------- Previous update was at 11:50 AM ----------
So it looks like all I was missing was a good old reboot.
For the storage to be mapped properly, I had to reboot and start from a clean slate. (Thanks to Thomas Connerly @ symantec and his reply to an older post Gmane Loom )
Hi all, I have the following LUN which is showing OK with its two paths:
DEVICE PROPERTIES for disk: /dev/rdsk/c23t500507630A3BC579d123s2
Vendor: IBM
Product ID: 2107900
Revision: 3010
Serial Num: 75WB0114900
Unformatted capacity:... (13 Replies)
Hello,
I have Solaris 10 running on one of rack server with dual port FC card. Each port of FC card is connected to two switches respectively. I have been trying to test multipathing functionality with one of FC Storage.
While I have two storage controllers , each connected to the two switches... (2 Replies)
Hello,
I have Solaris 10 running on one of rack server with dual port FC card. Each port of FC card is connected to two switches respectively. I have been trying to test multipathing functionality with one of FC Storage.
While I have two storage controllers , each connected to the two switches... (0 Replies)
Hi, I have a question regarding HBA configuration. Here are the commands' output:
# cfgadm -al | grep fc
c1 fc-fabric connected unconfigured unknown
c2 fc connected unconfigured unknown
c5 ... (11 Replies)
Hi Gurus out there...
I am pondering over a situation where I have non-root access (user account), where I am trying to determine paths (including multipaths) on a host.
"luxadm display" seems very appropriate, but requires root access.
Is there anyway I can get the FC path information?
... (1 Reply)
hi fren
i am facing this problem
i have sun 6140 storage
30 volumes
bt my vxdisk list output is showing 37 disk
which shd nt b there
has neone faced this proble earlier
vxdiks list output is like this
SUN6140-2_0 auto - - online c4t201700A0B84853C0d2s2
SUN6140-2_1 auto - - online... (13 Replies)
Weird question I know, but I'm intrigued.
Say for instance you have an Application in an SG with the usual start/stop/monitor. To successfully probe does it just check for existence of the script/file ?
Thanks... (1 Reply)
I have run init 0 to bring it to OK prompt.
I know that probe-scsi-all can hang the system.
I want to know what is the difference between probe-scsi-all and probe-scsi.
I was told that probe-scsi-all external and internal devices and probe-scsi shows only internal devices. what dose this ... (3 Replies)