I prefer snmp. I do not have the proper perl modules loaded on the platorm. Snmp isnt loaded on the platform. Telnet is not an option. I need to write an expect script to pull cisco equipment configs.
The following code is executed once I gain access.
the running config is large.
HI all
i need to connect to about 900 cisco routers and switch to do some configs changes. the issue i am having is that half the devices have one set of username and password and the other half have another username and password. From expect or bash script i can ssh into a device and make... (0 Replies)
Ladies & Gents,
Can one of you gurus please show me a very simple "expect" script to change the password in Solaris in a script, please? Nothing fancy, no error checking, no nothing. Just to change the password of a new user, it's all.
Many thanks in advance. U guys have honestly earned my... (1 Reply)
Hi all,
I use a bash script which use expect to connect throught ssh and run command on a cisco router. The ssh connection with expect work fine, but the first command on the cisco router failed,
I try to run the command in error by hand and it work fine... :(
the first part of the script... (2 Replies)
Hey everyone,
I have a few question.
1. Is it possible to display cisco 'show run' output command to the application ??
2. And is there any ways to log in to the router instead of using telnet from telnet application???
Thanks in advance (0 Replies)
At times I find the need to test that the tacacs port 49 is open.
The code below works but is painfully slow because I have to wait on the timeouts.
Examples of possible responds
router1#telnet 10.11.20.14 49
Trying 206.112.204.140, 49 ... Open
route1#telnet 10.11.19.14 49
Trying... (1 Reply)
Hi everyone :),
I need sort Cisco configs to report but i cannot do the script to made this:
#### INPUT #####
config-register 0x2102
version 12.2
!
hostname Router
!
interface Ethernet0
description Red LAN
ip address 192.168.1.1 255.255.255.0
no cdp enable
!
interface Serial0... (6 Replies)
This Expect script provides expect with a list of IP addresses to Cisco IPS sensors and commands to configure Cisco IPS sensors. The user, password, IP addresses, prompt regex, etc. have been anonymized. In general this script will log into the sensors and send commands successfully but there are... (1 Reply)